Engine coolant sensor location and replacement

Question edited for clarity.
3 Questions made into 1.
2 Duplicates deleted. Refresh page to see your question.

What's the 2004 dodge ram 1500 temp sensor location?

Vehicle History https://www.vehiclehistory.com > questions > whats-th...
Apr 9, 2020 - The coolant temp sensor is located at the front of the engine bay on top of the engine near the radiator hose. Like. (3).

4 answers · Top answer: The coolant temperature sensor of Your 2004 Dodge Ram 1500 monitors the coolant used in the engine and if it is not working, timing and performance ...

Where is the coolant temp sensor located on a 2004 ram ...

JustAnswer https://www.justanswer.com > Dodge Repair
Jan 9, 2021 - It's located in the front of the intake manifold. I would check the engine coolant and make sure it's full before replacing this.Sometimes low ...

1 answer · Top answer: I personally wouldn't, as long as you leave the cap on, you will lose some, bu
Shown here in pictures and text.

https://www.google.com/search?q=2004+dodge+ram+1500+coolant+temperature+sensor+location

..

The coolant temperature sensor on a 2017 Volkswagen Passat is typically located on or near the engine. It monitors the temperature of the engine coolant and sends this information to the engine control unit (ECU) to help regulate the engine's performance and fuel efficiency.
In the case of the 2017 Volkswagen Passat, the coolant temperature sensor is located on the engine block. To access it, you may need to remove some engine covers or components to reach the sensor. The exact location can vary depending on the engine type and model specifications.
For a more accurate and detailed location, it is recommended to refer to the vehicle's service manual or consult a qualified mechanic. They can provide you with specific instructions for locating and replacing the coolant temperature sensor on your 2017 Passat model. Additionally, if you are not familiar with automotive repair and maintenance, it is advisable to seek professional assistance to avoid causing any damage to the vehicle.

The Engine Coolant Temperature Sensor is located in the coolant pipe, below the air intake pipe and behind the right cylinder head and is integral with the ECT sensor. The Engine Coolant Temperature Sensor is located on the back of the right cylinder head and is integral with the ECT sensor.
https://www.autozone.com/repairguides/Audi-Cars-1999-05/Component-Locations/Engine-Coolant-Temperature-ECT-Sensor/_/P-0900c152801c0f85

Not low input sensor...P0117 KIA - Engine Coolant Temperature Sensor 1 Circuit Low Input

Possible causes
Low engine coolant level
Faulty Engine Coolant Temperature (ECT) sensor
Faulty engine coolant thermostat
Engine Coolant Temperature (ECT) sensor harness is open or shorted
Engine Coolant Temperature (ECT) sensor circuit poor electrical connection

Just replace coolant temperature sending unit....

Sarah, The Engine Coolant Temperature Sensor on your Kia is located below rad hose driver side by exhaust manifold. May be a good time to flush coolant system when changing sensor.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
How to Replace Lower Engine Coolant Sensor

Coolant Flush How to Kia Sedona 2002 2005 2003 Kia Sedona EX 3 5L V6

2003 KIA sedona engine coolant temperature sensor location Google Search

Does it run when the engine is cold, how about with just the key on engine off

Automobiles: 2000 Ford Escort ZX2 4-cylinder 2.0L MFI DOHC

NOTE
The "left" side of the engine is the driver's side.

The Engine Coolant Temperature (ECT) sensor is a thermistor (a device which changes resistance or voltage as temperature changes). The sensor detects the temperature of engine coolant and provides a corresponding signal to the PCM (Powertrain Control Module - aka "the car's computer").

The ECT sensor is mounted in the following locations (small Ford engines):

1.8L engines: in the cylinder head
1.9L engines: threaded into the heater hose inlet pipe
2.0L engines: at the left rear of the engine

2.0L Zetec Engine

(1) Partially drain the engine cooling system using a clean container. If coolant is in good condition, retain for reuse.
(2) Disconnect the battery ground cable.
(3) Disconnect the electrical wiring connector from the engine coolant temperature (ECT) sensor.
(4) Remove the retaining clip and the ECT sensor.




Fig. 1 Escort ZX2 ECT sensor - The retaining clip is removed (at the solid arrow). Withdraw ECT sensor by gently wiggling/pulling in the direction of the dashed arrow.

To install:

NOTE
Coat the ECT sensor O-ring with clean coolant prior to installation.

(1) Replace the retaining clip and the ECT sensor.
(2) Connect the electrical wiring connector from the Engine Coolant Temperature (ECT) sensor.
(3) Connect the battery ground cable.
(4) Refill the engine cooling system. An inexpensive plastic "Radiator Funnel" will help with this task.

The ECT (Engine Coolant Temp sensor) should be located by the coolant thermostat housing or where the upper radiator hose connects to the engine. It screws in with a plug or small/short wire harness attached to it. -------------------------------- To replace ect sensor:---

1. Drain and recycle the engine coolant.
2. Remove the intake manifold cover, if necessary.
3. Remove the exhaust crossover.
4. Disconnect the Engine Coolant Temperature (ECT) sensor electrical connector.
5. Remove the ECT sensor.

see fig below:---

.Thanks.

It's located under the hood, driver side, upper engine area, mounted on rear of engine block behind cyl. head.