I have a minute mount plow, when I try to use it only goes to left and right side but doesn't go up, when I try to lift the plow goes to the right. What can I do

Broken Motor Mounts.Thanks MEGABUCK

First make sure you have a good cable feeding the solenoid battery terminal check with a test light if ok, turn the plow switch on and test both sides of the solenoid if there's battery voltage there check at the plow lift motor is it plugged in, if so check at the plow lift motor battery terminal and if it lights your light repair the motor....these motors are know for seizing or getting stuck if you take the cap off you can probably fix it, put a punch mark on the cap, barrel and end frame to ensure alignment when reassembled. I hope this helps. Take Care.

Are we talking about a snow plow that is connected to the front of a vehicle? I would check to see if there was an obstruction in the hoses that operate the right to left movement. Also see it there is something jammed in the plow limiting or restricting its movement.

Start by plugging everything in and pop the cover off the control part on the plow and check for magnetism on all 3 solenoids when you hit the various buttons on your plow controller. The pull should be very strong and noticable...a weak magnetic pull is likely just residual magnetism on your screwdriver. In my case, the S3 solenoid wasn't firing and that causes exactly what you're describing.

If your S3 isn't firing you can test the wiring by moving the S3 hot wire to the S2 solenoid. If your wiring is good the plow will misbehave in an entirely different way. Also get out your ohm meter and test the S3, if its good you should get 7 ohms on it.

You need to use the guide from Fisher and be methodical about it. Start at the plow and work your way backwrds towards the truck.

check the wiring connections on the plow solenoids to be sure they are correct, the second step is check the controller box, using a continuity check via multimeter set for DC voltage. I have an old western plow that had similar symptoms, and was the controller box.

Not familiar with model, but valves click at the same time motor is suppose to run. Check power and ground to motor (or try running it with jumper cables, but don't be where plow can angle and squish you. If good power but won't spin, clean brushes/commutator/check bearings in motor.

does the pressure release close to raise the plow?

there is a relay to it

check your connections, especially the main power plug in, i have used a small "c" clamp over the connection to aid in the same problem