I have a 98 Chevy Malibu My car was hit on the driver side weeks later the headlight stopped working I replaced the whole headlight nd bulbs The auto low or high beams work but only in one head light

SOURCE: how to change bulb on drivers side low beam head light

My niece has a jimmy, they should be the same. The inside should be the high beam, the outside the low, DO NOT TOUCH THE GLASS ON NEW BULBS! Oil will cook on them and pop them! Both come off the same way. Take off the big rubber thing. They are soft but over hard plastic. Just pull them off. If you have trouble, you can flip the little wire clips that hold the headlight housing in place, this will give you room to see the rubber caps enough to figure them out better. The bulb assembly rotates CCW counter clockwise, and should slip out easily. Take the wires and plug off. it should be obvious how it pulls off. Snap the new bulb into the wires without touching the glass part. Gently replace in backwards order as you removed it. Put the rubber caps on, they keep water off the bulbs. It will break them!

The passenger side was harder for me. I had to take the air cleaner off, the whole cover and filter.You should be able to see or feel the same type caps, The low beam outside, High beam inside. The same 2 wire clips are there to release the housing. Everything pretty much goes the same, other than the air cleaner has to be removed and replaced. And make sure the rubber cap is replaced! Good Luck and good motoring!

SOURCE: low beam headlights not working

check voltage at switch

SOURCE: high beam headlight does not work properly

it more then likey a lose wire or bear one. run the line down. i think that the high beams run on diff. fuses. you can try that!

SOURCE: Audi A4 2002 Low beams & Right front turn signal stopped working

but on 2002 A4, F20 and F21 are empty! Does anyone has an idea where the headlight fuses located?

SOURCE: low beam headlight drivers side don`t work. high beam it works.

Check tour bulbs first and replace if blown. If OK then check wiring backwards from light to dip switch.