I, feel sorry for you, after reading your problem, but don't worry you visit the Reliable-Store they will help you for sure.
Best Manuals
SOURCE: Where is the vertical adjusting screw for the
open the hood, right above the lamp are the adjusting screws, with a built in level on most cars now days
Testimonial: "Thanks very much, I'll go try aim them up now."
SOURCE: headlight adjustment screws
They will probably be inset adjacent to the headlight. You'll find a horizontal and a vertical adjusting screw, with small springs behind them. Some cars come equipped with a small level (like a carpenter's level) attached to the top of the headlight under the hood to help you get the correct adjustment.
SOURCE: Where are adjustment screws on
On top of the housing of the headlight, you will see some small holes. With the use of a flashlight, look through these holes and you will see some torqux screws (T-20 or T-25 star bit). First loosen the headlight housing. With the use of the stars bits, adjust the headlight as needed and then re-tigthen the housing. You're done.
SOURCE: location third brake light wires
you can use one of the wires from either brake light and make yourself a good ground in trunk and running the two wires to you light switch. be careful where and how you run wires around the trunk hindges as you do not want them to become pinched and short out as that is a safety issue and get you pulled over. always solder and heat shrink all splices and wire to wire connections, if you dont you will hate your self later as wire from front of car to back of car could then need to be replaced.
I’m happy to assist further over the phone at https://www.6ya.com/expert/christpher_f760d0f18f8eedc3
1,658 views
Usually answered in minutes!
×