Daihatsu terios kid 2001 temperature gauge not working.....at first it use to go about halfway when am driving then about 5 minutes after it goes right down. But now it's just stays down I ....but I had replaced the temperature sensor alredy. Any idea?
The fan only operates when the engine/coolant temperature exceeds the thermostatically controlled fan. At idle observe the dash engine temperature and fan. Before the gauge reads above normal the fan should operate.
SOURCE: 2008 Daihatsu Terios engine number location on the car
wow someone knows their stuff ,if not sure where numbers are i ask in our local annual vehicle inspection station ,dont you have one??
SOURCE: Temperature gauge shows hot but the engine is normal operating te
replace temp sensor for the emission system. there are two on the engine.
SOURCE: Audi A3 2002 model auto - temperature gauge not working
The guage and fan speeds work on independant sensors. If you can remove the plastic engine cover and locate the "sending unit" for the gauge disconnect it and restart the engine. The gauge should remain cold and not move. If this is the case replace the sending unit. This should be a single wire sender located in the waterjacket of the intake manifold look in the area where the upper rad hose enters the intake.
SOURCE: 2002 Jeep Grand Cherokee 4.0L oil pressure gauge reading too high
if the gauge starts a 0 - goes to 1/2 , than full - sounds like gauge is OK - seems to me like the sending unit is bad - you could try removing the sender and trying to clean out the port with "brake clean", letting it dry than re-installing it. the pressure switch is still the least expensive place to start
SOURCE: Cigarette lighter fuse for Daihatsu Terios. Where
the fuse you are looking for is lockated under the dash at the drivers side if you remove the small change hilder you will see it it a blue 15 amp on the right hand side of the box hope this helps
Air
Temperature Control Blend Door Failure
In
all modern cars there is a tiny DC electric motor driven gear drive
that moves a plastic door that blends heated and cooled air from the
AC and the heater core, this is called (interestedly enough) the air
temperature control blend door actuator. The motor that moves this
door fails because the door starts sticking from warping, most common
complaint is no heat but it can be no AC as well. To replace these
parts (blend door and blend door actuator) you must remove the entire
dash from the car.
593 views
Usually answered in minutes!
×