Question about Cadillac Cars & Trucks

1 Answer

What is the idle relearn procedure for 2004 cadillac cts 3.6

Posted by ChucknWendy Chiow on

Ad

1 Answer

paulmacintyre

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cadillac Master
  • 3,218 Answers

The idle should relearn by itself within a minute or so if there are no other problems. Was the battery changed/disconnected? Why do you think you need an idle relearn?

Posted on Nov 16, 2015

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to removed and install The ECM


Your better off taking it to the dealer , after replacing it needs to be programmed or it will not run . Information from the old has to be up loaded to GM Tech 2 scan tool to load on new one ! Then you would need to pay for a subscription to GM'S service programming system to get software to program new ECM .
Program the ECM. Refer to Service Programming System (SPS) in Programming. If you encounter an ECM programming error, with a display message of "Starting Disabled, Remove Key" on the driver information center, with a diagnostic test code (DTC) of P1631, perform the "10-Minute Relearn Procedure" found in Programming Theft Deterrent System Components. Refer to Programming Theft Deterrent System Components . Additional information can be found in service bulletin number 05524 A. Turn OFF the ignition for at least 5 seconds after the programming event is complete. Perform the idle learn procedure. Refer to Idle Learn . Use the scan tool to clear all DTCs.
Of if you a few grand you could buy a J2534 programming tool an
J2534 Reprogramming Tool

May 06, 2015 | 2004 Cadillac CTS

1 Answer

Where is the idle control sensor for 2004 Cts Cadillac


There is none.Idle is controlled by your computer. If you have problems, check these. Vacuum lines behind throttle body. You may have to replace your air flow sensor. You can also try this:
Engine cold.
Turn your key to on position for a full minute. Don't start the car.
Turn key off for 10 seconds
Turn key on for 10 seconds. (Don't start)
Turn key off for 10 seconds. Then start the car. Might work but in all probability your main airflow sensor (MAP) is the problem.

Mar 11, 2015 | 2004 Cadillac CTS

1 Answer

MY CADILLAC 2004 CTS CRANKS AND DIES WITHIN SECONDS. IT DOES IT ONLY OCASSIONALLY


Replace the fuel filter. Hope the fuel pump isn't on the way out, cause it is expensive.

Mar 03, 2015 | 2004 Cadillac CTS

1 Answer

Idle relearn procedure


ThIs can be caused by a faulty throttle body.

Feb 13, 2015 | 2004 Cadillac CTS

1 Answer

What does if mean when battery saver is activated on 2004 Cadillac cts


Generally it means you are drawing more power than the alternator is putting out, or if the engine is off the stereo or some other accessory is drawing power. The battery saver is warning you that you have just enough power left to start the engine. Could also mean you have a bad battery connection or your alternator is not putting out over 13 volts. If the engine is idling with air conditioning and stereo on for any length of time it could also trigger this warning as the alternator at idle speed may be unable to keep the battery at full.

Jul 21, 2014 | 2004 Cadillac CTS

3 Answers

Whichnis number one cylinder on a 2004 Cadillac CTS with a 3.6 engine?


2004 Cadillac CTS 3.6L SFI DOHC 6cyl
Firing order 1-2-3-4-5-6 ------- front ' 1 3 5 ' of ' ' vehicle ' 2 4 6 ' ------- distributorless ignition


2004 Cadillac CTS 2.8L SFI DOHC 6cyl
Firing order 1-2-3-4-5-6 ------- front ' 1 3 5 ' of ' ' vehicle ' 2 4 6 ' ------- distributorless ignition


Hope this help (remember rated this free answer).

Jun 03, 2011 | 2004 Cadillac CTS

1 Answer

It seems the battery in my 04 cadillac deville is dead. I know the battery is located under the rear seat. Can I remove it without adverse effects on the computer?


you can replace battery with out effects.first turn off radio.before removing negative battery cable.when you install new battery, when you start the engine let it idle until get operating temperature.the computer will have to relearn it memory while engine idling operating temperature.open throttle a little see if engine hesitate. it will hesitate some, when you can accelerate with out hesitation,engine tps sensor has relearned it position.if idle speed stable engine dont run rough and stall out in drive your pcm has relearned itself where you can drive it.

Apr 03, 2011 | 2004 Cadillac Deville

1 Answer

Procedure to change turn signal light bulb on a


Remove 3 or 4 of the plastic pins holding the inner fender. They are located around the lip of the fender opening. The pins are removed by pulling the center cap of the pin straight out about an 1/8" and then wiggle and pull the whole pin out.
Pull the inner fender down and back.
Reach your arm in and grab the socket and squeeze the locking tab.
Rotate the socket counter-clockwise less than a quarter turn, and pull straight back.
Reach your other hand in and remove the bulb by pulling it straight out of the socket. It takes a 3157 bulb

Mar 30, 2010 | 2005 Cadillac CTS

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

755 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...