Isuzu 4fe flywheel and clutch pressure plate torque settings please

See the link

https://www.google.com/search?q=1992+Isuzu+amigo+2.6l+flywheel+pressure+plate+torque

..

Torque Specification - National Truck Spares ' Parts

www.nationaltruckspares.com.au/Parts.aspx?ProductTypeID=8...

1073, 4BC2 tq, Isuzu, Torque Specification, KT26 TLD57 NKR57 NPR57 ... 1075, 4HF1Tq, Isuzu, Torque Specification, NKR66 NPR66, 92 - 03, 4HF1, 4334

Small Block Chevrolet V8 Engine Specs ' Torque Specs ...

boxwrench.net/specs/chevy_sb.htm

Flywheel (Clutch). Thread Locker, 60 ft-lbs. Clutch Pressure Plate, Thread Locker, 35 ft-lbs. Centerbolt. (Harmonic Damper). Engine Oil, 60 ft-lbs. Bellhousin

Isuzu Workshop Manuals

If the clutch is not disengaging when you put your foot on the clutch ( if the system has been bled correctly or cable fitted correctly ) then the problem is that the clutch plate is in the wrong way round and the clutch hub with the springs is hitting on the flywheel bolts

Just a long shot,but do you have the clutch disc in backwards?
It only goes in one way in most vehicles.Flywheel side to the flywheel.

did you use a pilot spline to align the clutch and did you change the pilot bearing in the end of the crank. The clutch plate maybe interfering with the pressure plate if it is not lined up.

The flywheel bolts call for 52 lb-ft, the pressure plate calls for 13 lb-ft. Tighten in a diagonal pattern, one or two times at a time until seated then apply the final torque.
I have attached an image for reference. Goodluck

Lets start with what was replaced : Clutch pressure plate, throwout bearing,pilot bearing,input shaft bearing, was flywheel cut or replaced,Clutch cable or slave cylinder (whatever is applicable,) Lets see what repair shop says. Depending on what they say they did or didn't do we will take it from there.
keep me posted

flywheel 80-90 foot lbs (new bolts 90), press plate 45 foot lbs

the flywheel is 50 -60 ft.lbs....pressure plate is 15- 25 ft. lbs..