Then all you have to do is make the clutch tighter
SOURCE: replace clutch kit on 1995 chevy pickup
pretty simple jub any mechanic can do , but lots of work , Gear box has to come out , and drive shaft removed
SOURCE: 1989 jeep wrangler wont shift gear and clutch gone loose
Get the clutch slave cylinder and master cylinder looked at.One of the 2 has failed.If the pedal goes to the floor or is very loose,this is very likely the cause.Not an expensive fix.Hope this helps
Testimonial: "succinct. precise. prompt. thank you so much."
SOURCE: 1993 Nissan Sentra SE-R stick shift is moving to loose.
check the transmission selector rod, it just happened to my car last week. i could do reverse when i found out it broke. one thing that might caused it is too much pressure applied on the stick shift.
SOURCE: 2001 Saturn manual stick shift just popped and
sounds like your washers/bearings/spacers finally degraded. To make sure, pop off the little flexy cover. You will see a linkage that goes straight into the transmission. If the bearings there (the little white plastic ones) look eaten up, that's most likely your problem.
There is something not connected, What was the original issue?
415 views
Usually answered in minutes!
×