2004 dodge stratus 2.7 L v6 200i--2006 engine identification is EER has twin cam shafts and the bolts that hold the sprockets to the cam shaft are at 21 ft/lbs
there are 4 bolts for each cam (autodata publication page 375)
if this is not your engine then comment as to how many cam shafts it has as there are many different settings for different dodge engines
SOURCE: i need torque specs for a 2004 dodge cummins 24
http://www.dieseltruckresource.com/dev/index.php
I suggest this website for your dodge truck needs.
SOURCE: I need torque specs for the head bolts on a 2004
For 2004 Dodge Stratus 2.4L SFI SOHC 4cyl the Head Bolt Torque sequence
------------
| 10 6 2 3 7 |
| 9 5 1 4 8 |
------------
Step: 1 - Torque to 25 ft/lbs
Steps: 2 - Torque to 50
ft/lbs
Steps: 3 - Torque to 50 ft/lbs
Steps: 4 - Turn 90 degreesRecheck
final torque in sequence
Caution:Engine uses torque to yield head bolts
(TTY) that permanently stretch during initial installation. New head bolts
must be used when cylinder headis replaced or re installed to obtain
proper torque specification.
Hope helps (remember comment and rated this).
Testimonial: "I appreciate your quick response. Thanks"
SOURCE: NEED TORQUE SPECS AND SEQUENCE FOR 02 DODGE 2.4 V6 STRATUS
How do I know how to put the torque converte on the same holes like it was be fore to the fly wheel
746 views
Usually answered in minutes!
×