'88 6.2l diesel crew cab. Where can I get a diagram that shows wiring from battery to starter?

SOURCE: 2005 nissan frontier crew cab won't start

Make sure you have 12 volts from the positive side of the battery to the starter. Check the small wire on the starter solenoid and make sure you have 12 volts when cranking engine. If voltage is correct, the starter is bad

SOURCE: 7.3 diesel won't start, but turns over no problem. No fuel

this should not have a emergency shut off they are on gas engines not diesel engines 
if you have the electronic injectors it could be the shitch on the high pressuer oil pump is bad or other problems with high pressure oil system pump lack of oil in resovor ect  also check all fuses and relays under hood  these are not as user frendly as the older 7.3 s  were good luck

Jim Goldsmith

• 2005 Answers
• Posted on Apr 21, 2009

SOURCE: Fuse panel diagram for 2003 - F250 Super Duty -

I beleive the diagram is on the inside of the plastic fuse cover, mine is.

SOURCE: i NEED A FUSE BOX DIAGRAM FOR A FORD F150 2006

if your replacing a fuse... just ck all the fuses with a test light with ignition in on position...

SOURCE: ... Replaced battery in a 2005 Chevy Colorado Crew

something puts bcm into safe mode. take neg. battery cable off and touch it to pos. post for 30 sec. leave unconnected for 6 hrs then reconnect. should work after that. just did mine. dealer wanted 400$ to change door switch