Horn does not work at the steering wheel, but its sound when the doors are lock for the key remote anyone else having this issue?

test steering wheel switch for failure

Sounds like you have an issue with either the steering wheel or the clock spring. You need to find someone that is experienced with working on vehicle SRS systems as your air bag module will need to come out for diagnosing your problems.

Does the horn sound when you press it on the steering wheel if not check for a blown fuse to horn and then if ok see if you have power to horn and then if that is ok run a wire from the battery to the horn and see if it honks.

what else did you have done that would have required the steering wheel removal
there is no connection between a steering knuckle ( ball joint ) and the steering wheel problems you describe

System Description
The horn system consists of the following components:
?€¢
HORN fuse

?€¢
Horn relay

?€¢
Horn slip ring

?€¢
Horn switch

?€¢
Horn assembly

?€¢
Body Control Module (BCM)

System Operation
The vehicle horn system is activated under the following conditions:
?€¢
The horn switch is depressed.

?€¢
The body control module (BCM) commands the horns on. The BCM commands the horns on under any of the following conditions:

-
When the panic button is depressed on the remote control door lock transmitter. For further information refer to Keyless Entry System Description and Operation .

-
When the keyless entry system is used to lock the vehicle, a horn chirp may sound to notify the driver that the vehicle has been locked. The notification feature may be enabled or disabled through personalization. For further information refer to Keyless Entry System Description and Operation .

see the diagram attached and fix it. test any wires loose+corroded+test the fuse+ the relais with VOM +button for dirty or faulty, and+horn itself for loose wires , adjust the screw for soudn.God bless you

i'd say 2 completely different issues,did key work when you bought vehicle,i'd say ones a replacement and they may not have coded it to immobiliser,horn may be horn itself ,but often the moving parts behind steering wheel fail,have you checked the fuse?the relay can often fail to

Your horn contact in the steering assembly probably uses what is called a 'slip-ring' type contact and the 'ring' which is part of the steering wheel itself may be contaminated or the stationary contact, which uses low-pressure spring material, is either worn or the spring has grown weak. You will have to gain access to the inside of the steering wheel center section to check this.
Also, unless you have actually electrically tested the horn relay, I would check for a relay with the same part number (should be stamped into the case) and temporarily swap them. Your security system may employ a separate relay to sound the horn when locking or unlocking.

Your lock settings were most probably changed from your remote unit. By pressing both lock and unlock keys together for around two to three seconds you can switch between silent mode and horn mode. Hooe that helps...

sounds as if the locking mechanism is wearing out or not making the proper connection to the steering wheel