Question about Cars & Trucks

1 Answer

Clutch replacement without a cherry picker - Cars & Trucks

Posted by Missy Houle on


1 Answer

Randy Ohler

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,585 Answers

Drop the transmission out the bottom. No year make or model. All the ones I do, come out from the bottom. way to much work to pull the engine.

Posted on Aug 24, 2015


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

What do i need to replace the motor in a 1998 chevy cavalier

Floor jack, jack stands, cherry picker, common sense, mechanical ability, basic hand tools, service manual helps.

Jun 08, 2015 | Cars & Trucks

1 Answer

How to remove the engine

The task requires mechanical skills and hardware such as a Cherry Picker. Without the proper tools; you cannot manage this function. In addition, you have to remove every attachment, fuel lines, support brackets, covers, plates, mounting brackets, electrical, and misc. devices. Then reassembly is difficult and you need a computer to reset the parameters set forth by Buick.

Mar 30, 2015 | 2009 Buick Enclave

1 Answer

How do I replace the motor mounts on my 2001 Toyota Camry Solora xle v6

Ok, first off apply E brake. Second, locate motor mounts usually on side bottom, connect to frame. Third jack up car place jack stands. Fourth,disconnect all wiring, maf, pretty much anything and everything that will get in way. Fifth, grab cherry picker, connect engine to cherry picker. Sixth, disconnect engine from trans, or leave connected but might be more difficult for some. Seventh,unbolt engine from mounts(usually 3or so bolts on each mount), do not rock engine, raise cherry picker(or crane some call it different)when tension on chain slowly rock engine. Should pop out unless you missed a bolt.

Feb 20, 2015 | 2001 Toyota Camry Solara

1 Answer

Motor mount

put a jack under motor to support the motor then replace. Might want to put a 2x4 and some rags or blanket between motor and jack to prevent damage

Mar 27, 2014 | 1995 GMC Sonoma

2 Answers

How do i replace a 1998 daewoo nubira clutch

You take out the gearbox to access the clutch.

Aug 30, 2010 | Daewoo Nubira Cars & Trucks

1 Answer

What is the best way to bull the engine on my 1994 ecoline van without a lift.

The only reasonable way to pull the engine out of a van is with an engine lift (cherry picker). You can buy a fair quality one at most auto parts stores for about $300 or you can generally rent one for about $15-$25 per day at many tool rentals.

Jun 11, 2010 | 1994 Ford Econoline

1 Answer

Crankshaft bearings replacement

Does the engine knock? Low oil pressure? Why does it need bearings. If the bearings are bad and you don't remove the crankshaft to have it turned, you will be doing this job more than once. no fun

Feb 28, 2009 | 1992 Mitsubishi 3000GT

1 Answer

Easiest way to remove bed on 1988 s-10

pull all bolts get a engine puller or as i call it a cherry picker and hook one chain to the hook by the passenger side closest to the cab and the other side to the driverside by the tailgate.then get another chain and do exactly the opposite so that you make an X the hook the cherry picker/engine puller to the center and lift slowly..

Dec 01, 2008 | Chevrolet S 10 Cars & Trucks

1 Answer

How do you change clutch on bmw m3 3.2 evo 1998

No, the engine does not need to come out. However, if you have ASC+T or even if you don't, you may finit useful to unbolt the throttle body from the intake manifold so it doesn't damage your brake fluid reservoir while you are lifting the front end of the engine in order to lower the back end of the tranny. Also remove your fan clutch and use a cherry picker on the hook over the water pump so the front of the engine doesn't come down and puts unnesscessary strain on your motor mounts.

Jun 06, 2008 | 1998 BMW M3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

85239 Answers

john h

Level 3 Expert

23515 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6521 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides