Maybe there's a short somewhere check wiring coming from fusebox
SOURCE: 1989 Acura Legend V6L
if the battery drains dead there is a leak in the wiring some were
some thing is not turning off
SOURCE: Acura Legend Sedan 3.2 lts 1994
replace de ignition module first.. if still wont start good chances is the crank sensor is located behind the timing belt.. my 94 legend use to do the same thing until i replace the crank sensor.. and also if u can afford i will suggest u to replace the main fuel relay too... all this is after u are 100 pcnt sure that ur fuel pump is working....
SOURCE: my 1994 acura legend keeps overheating
when bleeding the system to get the air out, you may want to turn of the heater to help get all the air out of the system.
SOURCE: how do i losen tension on 1990 acura legend
If you lean into the engine compartment from the passenger side to look at the pully side of the alternator, you will find a bolt (10mm I think) sort of behind the alternator and to the back left. It is sticking straight up, and you can use a nut driver or ratchet to turn it counter clockwise to loosen tension and lower the alternator. But you have to loosen the locking bolt first. When you look at the pully side of the alternator (once the plastic shroud is removed to expose the belt and pully) you will see 2 large bolts (one on the bottom right and one on the bottom left) on the alternator that hold it in place. The one on the bottom left (on the same side as the tension adjusting bolt) is the locking bolt. You will see that there is a track for it to slide along as the alternator swings up and down. If you loosen this bolt, the alternator should be free to swing down on the left side when you adjust the adjusting bolt. However, it is common for the alternator to stick even after you have loosened the locking bolt and . When I adjusted mine, I had to remove the bolt on the bottom right because my alternator had been in there so long is was stuck in place. (The alternator is supposed to pivot on the right bolt, but sometimes it sticks.)
SOURCE: Can you disable car alarm in 1991 Acura Legend by
If it's a cheap aftermarket alarm, check for a red wire coming off the hot side of your battery with an inline fuse. If it's not, try to locate the alarm "computer" under the driver's side dash or nearby your fuse panel. You'll find a black box with a wiring diagram glued to the side, normally strapped to a wiring harness or other fixed element. If this is the type of alarm you have, you'll need to trace each wire coming from the alarm computer and unclip each fastener that's clipped to your vehicle's factory wiring. The trouble with these types of alarms is that they can get power from a number of sources (stereo, interior lights, etc.). Good luck with this one!
122 views
Usually answered in minutes!
×