My 1997 Venture will not park the windshield wipers when I shut them off. Replacing the wiper motor won't help.

For the Honda civic 2006, a 24 inch windshield wiper is needed for the passenger side and 28 inch windshield is needed for the driver side.------------------------------------------------------------------------
ELM 327 1.5V USB CAN-BUS Scanner

Might need to replace the switch

WINDSHIELD WIPERS

It can be faulty wiper motor or blown wiper control fuse.

Do you hear any kind of noise when you starter the wiper function. If yes then fuse is ok, but issue is wiper motor.

If no movement at all and no noise then its blown fuse or shorted/loose wiper control wiring: -----

For complete troubleshooting i suggest you few helpful links with accurate solutions.

-------------

Click the link below: -------

1993 Ford F350 wipers not working?

http://repairhelpcenter.blogspot.in/2012/02/1993-ford-f350-wipers-not-working.html

------------

How to Replace a Windshield Wiper Motor

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-windshield-wiper-motor.html

------------

Wipers not working, but hear relay click on Lincoln LS?

http://schematicsdiagram.blogspot.com/2011/12/wipers-not-workingbut-hear-relay-click.html

-----------

Car windshield wiper gets power for movement and stops?

http://schematicsdiagram.blogspot.com/2011/12/car-windshield-wiper-gets-power-for.html

----------

How does cars Windshield Wiper System Works

http://technoanswers.blogspot.com/2011/11/how-does-cars-windshield-wiper-system.html

---------

1997 Honda Protege: Replace Wiper Transmission?

http://technoanswers.blogspot.in/2012/06/1997-honda-protege-replace-wiper.html

----------------

Windshield wiper fluid container leaking?

http://whatisbyme.blogspot.in/2012/05/windshield-wiper-fluid-container.html

-----------------

Where is wiper fuse located on1993 chevrolet suburban

http://technoanswers.blogspot.in/2012/02/where-is-wiper-fuse-located-on1993.html

------------

2002 Toyota Sienna: Wipers and Passenger side Power window stopped working?

http://technoanswers.blogspot.in/2012/04/2002-toyota-sienna-wipers-and-passenger.html

-------------

Complete wiper components replacing details for Acura Car Models?

http://repairhelpcenter.blogspot.com/2011/11/complete-wiper-components-replacing.html

------------

These details will help.

Thanks.

To Question on Windshield wipers stay on. Your parking paw is defective. Its best to replace the windshield motor, There usally easy to replace

Remove arm(s), put wiper motor in park,(shut off) then re-install arm at base of windshield where they were before,when shut off.(in park position.)

Check that you have connected the wiper motor correctly - ensure that you havent inadvertently got the polarity wrong!.
Leave the wiper arms off until you get the motor to run and park using the normal wiper on/off switch.
The motor 'park' control switching is normally an integral part of the motor drive gear and is not adjustable.
During your testing, affix a temporary indicator pointer to the end of a wiper arm drive shaft (use masking tape or similar) to prevent damage to motor or levers.

There is a wiper pulse board on the wiper motor itself that is failing, this can be replaced without replacing the entire unit.

It is the Wiper Motor causing the Problem and will need to be Replaced. They could have caused it by Bumping the Wiper Motor Casing when replacing the Hood or when Working on the Motor. Please Rate my Response, I need all the HelpI can get! Thanks!

The problem is in the wiper motor assembly. Did you ever notice that when you switch the wipers off they always go back to the home position? This is due to a switch that keeps the wiper motor operating until the wipers are parked. In many older GM vehicles this is accomplished with a leaf type switch which opens when the wipers are in the correct position. when the dash switch is turned on this switched is bypassed keeping them on-when the wipers are turned off the motor continues to operate until this connection is broken.

Inside the wiper motor housing there is a nylon gear that drives a cam that cycles the leaf switch-most likely the gear has become damaged so it no longer drives the leaf switch allowing the switch to remain closed. A cheap fix is to disassemble the motor unit and piece of tape between the contacts. Although the wiper will not park properly they once again can be controlled by the dashboard switch.

In later vehicles the wiper position is located with an electronic sensor with a small PB board - the repair of this gizmo is beyond the scope of most shade tree mecahnics - so the solution is to replace the entire wiper motor assembly - unfortuneatly.

disconnect the wiper transmission from the motor, then run the motor and turn the motor off with the wiper switch, this will park the motor, re-attach the wiper trans linkage so the wipers are parked/down