Turn signals & hazards not working. Replaced comb. switch, relay and flasher. Still none.

help here

https://www.google.com/search?q=2004+Chevy+classic+flasher+relay+location

And just for information OP 'Anonymous', Jeff Armer, the guy you dissed is a vehicle electronics wizard, a professional who fixes problems like your 5 days a week every week.


..

Turn signal switch is probably the problem ,but without testing that is just a guess. Do know i replaced a few on grand am's . What relay ???? There is no relay in the fuse box for the turn signals . Your vehicle has turn / hazard flasher module .
Turn Signal Lamps
The TURN-B/U fuse and the STOP/HAZ fuse in the IP fuse block, supplies battery positive voltage to the flasher module. The turn signal lamps may only be activated with the ignition switch in the ON position. When the turn signal switch is placed in either the left or right position, current flow is from the flasher module's output to the turn signal switch assembly. The flasher module then sends an on-off voltage signal to either the left or right turn signals and their instrument panel cluster (IPC) indicator. When the hazard switch is pressed, all the turn signal lamps will flash including both IPC turn signal indicators.
Located under the driver side of the dash above the brake pedal ,on a metal bracket .
Turn Signal/Hazard Flasher Module
On the dash harness near the steering column

many lighting systems use two flasher relays to isolate turn signal function from hazard function. each has an independent power supply source path or circuit. you'll need to trace power to the bulbs from the turn signal switch, and from the fuse boxes to the switch.

Check the hazard switch. If the hazard switch is not working, ur signal will not work.....

Fast clicking is caused by a higher than normal current being applied. Normally a short or a aftermarket relay that requires less current to switch. Sounds like the entire multifunction switch is bad.

you may have a bad flasher relay. its also known as a hazard relay, or turn signal flasher.

I NEED TO LOCATE THE SWITCH WHERE IS IT ?
MY INDICATORS NOR HAZARD LIGHTS ARE WORKING I DONT KNOW WHAT IS WRONG WITH IT CHANGED BULBS BUT NOTHIGN THEY ALL WENT OUT AT THE SAME TIME
SO THERE MUST BE A RELAY SWITCH SOMEWHER BUT DONT KNOW WHERE ?
THANKS FOR HELPING

the hazard switch above the radio is your problem. if you put on your signals and they don't flash turn hazards on then off and they will flash. (changing this *** will fix your problem

there is another flasher relay (2 of them) one for hazards and one for turn signals .....replace that and advise here

i have a similar problem but my left signal works, when i turn the right on it just does an annoying buzz sound. if you can think of any explination for such shinanogins help would be greatly appreciated