Where are the right and left camshaft position sensors for a ford fusion sel 3.0 liter motor located on the motor.
SOURCE: locate the oxygen sensor on a 4.2 liter
In the exhaust pipes just down stream from the exhaust manifolds.
SOURCE: P0340 Code Camshaft Position Sensor
The Camshaft Position (CMP) Sensor detects the position of the camshaft in order to identifiy when piston No. 1 is on its compression stroke. The CMP sensor is used for ignition timing in the Ford DIS igntion system, but not in the EDIS igntion system. Both DIS/EDIS use the CMP signal for synchronizing the firing of sequential fuel injectors.
On the 3.0L vulcan engine, the CMP signal is generated by a single Hall-Effect magnetic switch, activated by a single "vane" spinning around by virture of a synchronized shaft which is driven by the camshaft.
The CMP sensor & synchronizer/shaft are located behind the intake manifold (i.e., back near the firewall on a Ranger) on the top of the cylinder block. If you just need to replace the sensor, it is a simple job of unplugging the electrical connector and removing the screws holding the sensor in place. Here is a sketch of the sensor to give you an idea what to look for:
SOURCE: P0344 Camshaft Position Sensor A Circuit Intermittent (Bank 1 or
The camshaft sensor is located right above the crankshaft pulley on the passengers side of the front cover of the engine. It will be a 3 pin sensor either gray or black in color. There is a pointer that is attached to the sensor and it is either gold or silver in color. There is also a recall out on this camshaft sensor. If the color of the sensor is black then it should qualify for the recall. If you get in touch with a Ford dealer they should be able to help you with your recall if the sensor is black since it is a safety recall. As far as your exhaust pressure sensor it is located on the front of the engine right by the heater core hose a little to the passengers side of the center of the front of the engine. there will be a tube attached to the bottom of the sensor that goes from it to the front of the exhaust manifold on the very front of the passengers side exhaust manifold.
SOURCE: Where is the camshaft position sensor located on a 1999 ford contour?
what is your engine size?? give me the eighth vin number starting from left to right..then i will be able to help you..
SOURCE: where is the throttle positioning sensor located
Please don't forget to rate!
Disconnect and remove the TP sensor from beneath the throttle body
View of the throttle position sensor mounting-4.9L, 5.0L and 5.8L MFI engines shown, others similar
Exploded view of the throttle body mounting-5.0L and 5.8L engines
1,310 views
Usually answered in minutes!
×