- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Car idle is rough Inspection Service & Cost
A rough idling engine can be caused by a number of issues, some of them are serious while others tend to be minor, but the symptoms remain pretty much the same. The car will feel rough and bouncy when the engine is running. The car will also idle below its regular speed, display inconsistent RPMs and may produce a shaking, skipping or slipping sound when the vehicle is running.
While a rough idling engine may seem to be a simple inconvenience it often indicates a deeper problem within the engine. The vehicle should be inspected and repaired as soon as possible because small problems have a way of turning into expensive repairs.
How this system works:
The idle speed of an engine is basically the rotational speed the engine runs on when it is un-coupled from the drivetrain and the throttle pedal is not being depressed. The idle speed is measured in the revolutions per minute of the crankshaft.
When an engine is running at idle speed it generates enough power to smoothly operate equipment such as the water pump, alternator, and power steering but not enough power to move the vehicle itself. A passenger car will usually idle between 600 RPMs and 1000 RPMs. A properly functioning idle should run smoothly without skipping or slipping.
Common reasons for this to happen:
Dirty Fuel Injectors: The fuel injection system injects fuel into the cylinders, which creates a mix of air, and fuel to ignite and burn. Fuel injectors have tiny nozzles to spray the fuel into the cylinder and they can become clogged over time. clogged or failing fuel injector creates a lack of fuel in the vehicle's engine. This can cause a rough idle, it can also cause symptoms such as slow acceleration or the car not feeling as if it has enough power. If the problem is addressed early, it is possible to clean the injectors, which will restore them to full function. If this condition is not addressed in a timely manner the injectors will need to be replaced. Incorrect Idle Speed: While the average idle speed falls between 600 to 1,000 RPMs, if your vehicle is experiencing a rough idle it could be due to an incorrect idle speed setting. A trained mechanic can easily adjust the idle speed, and it should stay at the proper speed. If an adjusted idle speed becomes inconsistent or changes at random intervals there may be a bigger problem that needs to be explored. Vacuum Leak: If the vacuum system has a leak, it can seriously affect the ability of the vehicle's computer to regulate the air to fuel ratio. This can lead to a rough idle and if the problem is not addressed the car may experience slow acceleration and a lack of power. Vacuum leaks should be inspected and repaired immediately. Incorrectly Installed or Damaged Plugs: Spark plugs are responsible for creating the spark that allows the vehicle to burn fuel. If spark plugs are improperly installed or malfunctioning, the idle speed can be affected. The vehicle's engine may vibrate or there may be slipping or straining sounds coming from the engine. Defective or Clogged Fuel Pump: A rough idle can be related to fuel delivery issues. The fuel pump, which is responsible for pulling fuel from the gas tank to the fuel injectors, can become clogged or defective. If this happens the engine will not get enough fuel, which can cause a rough idle, sputtering, stalling and even slow acceleration. Clogged Fuel Filter: A clogged fuel filter can cause similar problems. The job of the fuel filter is to screen out contaminants in the fuel, over time it will become clogged and need to be replaced. A rough idle is one symptom of a clogged fuel filter. Failing Electrical Components: A problem or failure in the ignition system or various electronic components can cause a rough idle. If this is the case, the problem will usually get worse as RPMs increase. Common culprits include the ignition control module, plug wires, coils, and spark plugs. Defective Airflow Sensor: A defective airflow sensor can be responsible for a rough idle. A mass airflow sensor detects the amount of air coming into the fuel injection system and sends that information to the vehicle's computer. The computer uses that data to deliver the proper amount of fuel to the air in the vehicle. Over time these sensors can malfunction or become dirty. One of the first symptoms of a malfunctioning airflow sensor is a rough idle. The car may also accelerate slowly and even stutter or stall as the problem progresses. Dirty Oxygen Sensor: Oxygen sensors measure how rich or lean the gases are as they exit the combustion chamber. Depending on the results, the amount of fuel entering the engine is adjusted by the vehicle computer. The ultimate goal is to maintain an ideal mixture that produces the lowest emissions. A dirty or failing oxygen sensor will usually trigger the check engine light and can lead to a rough idle, lower fuel efficiency and failed emission test.
replace the pvc valve and have the egr valve replace.make sure the vacuum hoses connect to egr valve and pvc replace.change air filter.all those things will cause high emission if not working properly.cause you to fail smog test.
Some vehicles require very specific drive cycles (called "drive traces"
if you perform them on a road simulator or dyno) to activate certain
self-checks like the catalyst and EVAP monitors.
As a general rule, doing some stop-and-go driving around town at speeds
up to about 30 mph followed by five to seven minutes of steady 55 mph
highway speed driving will usually set most or all of the monitors.
Consequently, if you're checking an OBD II system and discover that one
or more of the monitors have not run, it may be necessary to test drive
the vehicle to set the remaining monitors.
You should talk to a good emission tec, if this is not throwing a code, it is hard to say if that one of the components could be bad. O2,pump,convert, HeO2, every part of the emission system.
With a 1000 miles, and doing what is says above just before the test, and ending driving at the test should be plenty. If it is not, you will have to have each emission part checked, or when the computer is plugged in it might show a code that did not trip dash light.