Flywheel timing mark
SOURCE: Torque spec for flywheel bolt: Isuzu 2.5 diesel engine
normally 110 nueton metres. use nut lock and once you have torqued you will feel if you have to tighten it a bit more.
SOURCE: isuzu tropper 4jx1
You have no injection pump ,each injector does that job .
You have a faulty rail oil pressure sensor I think ,read my tips to test this sensor .
SOURCE: isuzu trooper 2002 RLV engine. camshaft timing
Sorry for the severe delay.
I am personally going back to answer your unanswered question.
I do not know if you still need the answer, but I am going to answer it in case you still do.
Click on the following direct Link. It has the Timing Belt Diagrams and Photos with Marks for the Camshaft and Crankshaft that you will need. It also has numerous other helpful diagrams, instructions and photo's for use.
Again my apologies...
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
http://www.2carpros.com/car_repair_information/year/2002/make/isuzu/model/trooper/2002_isuzu_trooper_timing_belt_diagram_marks.htm
SOURCE: isuzu wizard 4jx1 engine is
hi how can you help me coz i hit the pot hole with my isuzu wizard and the engine run off, i tried to start it again several time and it wont what could be the problem.please help.
SOURCE: 4jx1 camshaft marks on isuzu trooper 2001 3,0 dohc
the timming gear that the belt runs on has a mark (V cut in gear) to rear cover at about 12 o clock and crank pulley has timming mark for top dead centre, both cams have cut outs in rear that a special tool (camshaft stopper 5-8840-2592-0) locks into to hold cams in correct position, but can do without this, if the cam belt gear is off, the keyway should be at 12 o clock. the marks in the camshaft gears (dots) is for assembly of sissor gears to solid gears on camshafts that run together and they should match up only if you had this appart.
no.1 is timming mark
this is the locking plate tool
2,273 views
Usually answered in minutes!
×