Why do my Brake, ABS and Traction lights come on, the readout says traction ESC ?

fix the abs --to fix or get traction working [it needs]the abs sensor info have scanned for trouble codes as well

It can be a abs sensor causing the problem,if so,it will convert to regular brake system.It also can be a brake problem,,worn out brake pad.

NO !!!

By "were done" I am guessing someone else did the job for you. It is a common error at garages to forget to reconnect the sensors so that is my first thought but then you say you changed the front sensors, was that after the brake job and do you have 4 wheel ABS? The plugs for the sensors should always be cleaned if not replaced after a brake job in my opinion (high dirt area). More info will get you a better answer if you post back I may be able to help more/better.

2008 Escape has a terrible reputation for ABS light and traction control light being. All due to broken ABS tone ring cracked and out of position flopping on frt bearing. Go to local AutoZone store and they will scan this to find which wheel has the broken tone ring. The replacement ring is cheap in the $7 range. It is labor that will sicken you as this ring must be pressed on after the front half shaft is removed. Not a driveway job if you are considering DYI.

Check first the third eye brake light. does it work? okay the problem reside in a ABS sensor make sure it is hook up or if you recently did a brake job it didnt get contaminated. When the ABS signal is interfered with ESP,Traction is disabled. One or some of the wheel speed sensor is disconnected or is being interfered with. This is common for a recent brake job if any occured

If brake pedal is chattering or pulsating it is most likely because you need either front or rear rotors, or both. They are rusted or out of round. If there is something wrong with either your abs or traction control,the abs or traction control light will come on & stay on. As soon as these lights come on, it automatically disables abs or traction control. If you would like to take out fuse that disables abs or traction control circuits, it will leave the lights on.You just wont have their functions. If by some strange condition your chattering goes away, then there is indeed something wrong with your abs or traction control.Fuses are labeled abs or traction either under hood or in your fuse panel in car.

well the cruise light is blinking probably becuase its telling you its notworking due to the fact the abs/traction lights are on,youre saying you just got a brake job done, i would guess either they unplugged the abs sensor to gain acess to the brakes or the sensor for the abs got dirty when they disrupted the brakes by removeing them to do the brake job, first thing i would do is peek at each wheel and see if the abs sensors are plugged in, if they are the next thing i would do , is remove each of the front sensors and clean them with brake clean or something like that,,the sensors are little magnets and sometimes when working in that area rust and dust and stuff gets on them and interupts the signal and casues all the problems you have list,,,,hope that helps,,,or take it back to where you got the brakes done and tell them about it and they should look at it and maybe fix it for free ,,,

ABS and traction control really are only for panic stops and if your tires slip on wet surface's and yes each tire has a sensor on it. However if the brake light comes on this has nothing to do with the ABS or traction control lights. It's not a parking brake light. This light tells you, you have a serious brake problem.

bad wheel bearing.will make noise and mess with sensors,or if had a brake job done caliper maybe loose to cause noise,if a drum which most are not you have parts rolling around in it,have seen it all.
traction control and abs use same sensor,you could have debris in caliper a little pebble between brake shoes and rotor will cause issues.