Question about 2013 Dodge Avenger

1 Answer

How to reset the check engine light on 2013 dodge avenger without a obd2

Posted by Jake Hensley on


1 Answer

beau story

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    Visited the website for 3 consecutive days.

  • Expert
  • 108 Answers

If theres used to work with older trucks not sure now , you can disconnect the truck battery for 24 hrs before you reconnect the battery.

Posted on Jun 19, 2015


5 Related Answers


  • 158 Answers

SOURCE: 98 dodge avenger transmission problem

codes will verify if it needs to be pulled out. More than likely it will as the electronics are rarely the problem. The computer senses a indifference in the ratio between the sensors so it locks it in limp mode - 2nd gear.

Posted on Apr 06, 2009



  • 335 Answers

SOURCE: 2008 Dodge Avenger: How to get codes when check

Need to use a code reader to read and reset check engine light.

Posted on Jul 27, 2009


  • 31 Answers

SOURCE: Check engine light came on. OBD2 gave me 5

Take it to autozone. If you live in USA. They have a thing that checks and they will tell you exactly what the codes mean.

Posted on Sep 04, 2009

John Jon

  • 1114 Answers

SOURCE: check engine light reset

usaly You use a OBD 2 Scan tool if you do not have one you might want to disconect battery for a minute then reconect the battery how ever keep in mind if you do not fix the switch that cause the *eng light* to come on it will return when you start the car up again,Hope this helps ,John

Posted on Dec 22, 2009


  • 42 Answers

SOURCE: I have a 2008 Dodge Avenger and the check engine

sounds like your have a misfire in one of your cylinders...a flashing check engine light with engine running rough. Check your sparkplugs and wires. you should have the code scanned.

Posted on Jan 06, 2010

Testimonial: "Sweet"

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Dodge Avenger 2013 - Horn honks once every time I physically open the drivers door? No warnings in message center and no indicator lights on in dash- could this be a low battery in key fob?


Replacing the battery requires no special programming.

So long as you have at least two (2) programmed
keys (up to eight are supported) you are able to add
additional keys or REPROGRAM your RKE fobs
(remote keyless entry fobs) ... YOURSELF.

Check page 19 of your OWNERS MANUAL
( 519 pages: OR CLICK HERE )
Dodge Avenger 2013 Owner Manual Replacement Keys

Hope this helps

Carnac the Magnificent

Jan 03, 2018 | Dodge Cars & Trucks

1 Answer

Engine light on on 2013 avenger how do i reset it

To reset the Engine light on an O.B.D II* Car/Truck you will need and O.B.D II* scanner. You can get these scanner's from most auto part's store's. And here's a link to

FOXWELL NT301 OBD2 Diagnostic Live Data Reset Code Reader CAN Check Engine...

In the olden day's of car when we were with O.B.D I* you cud have reset the code's by unplugging the car battery for 10 seconds.

* On Board Diagnostics*

Oct 23, 2017 | Cars & Trucks

2 Answers

2013 dodge avenger doesnt start

Check for fuel spark,and a good battery

Sep 28, 2016 | Dodge Cars & Trucks

1 Answer

Avenger warning lights

Have codes scanned and post them here.

Jul 24, 2015 | 2013 Dodge Avenger

1 Answer

How to reset the check engine light on 2013 dodge avenger

Use scan tool to erase codes, or have parts store do this.

Jun 19, 2015 | 2013 Dodge Avenger

1 Answer

2008 Dodge Avenger. The check engine light was on. Had it reset at Autozone. They said it was the Power Control Module Code. I drove the vehicle for a while. One day acted like a dead battery. When I

well it seams that Power disconnected, I mean do you have any security device kind of remote security device , it have power shut down from there for security reasons... so check it from there ...
best of luck if you have any further problem feel free to mail me [email protected]

Nov 22, 2013 | 2008 Dodge Avenger

2 Answers

I have a 2000 Dodge Avenger. The check engine light came on as soon as I hit 90,000 miles. A friend said they are set to do that and that it can be reset. The car seems to be running fine. Is the check...

If you take it to a auto parts store they can help you get the code out of your cars computer. This will not cost you anything and may help identify the probelm. I use Autozone and Carquest for my parts stores.

Jul 13, 2009 | 2000 Dodge Avenger

Not finding what you are looking for?
2013 Dodge Avenger Logo

2,238 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers


Level 3 Expert

4372 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides