Where is the low pressure port on 2003 peugeot 206

The high pressure port is much larger than the low pressure port. It is impossible to hook a charging hose to the wrong port. If the charging hose is leaking, it is either because it is not clicked all the way on the port or the charging hose connector is defective.

The high pressure port is located on the discharge hose just to the rear (driver's side) of the A/C compressor.

You missed the correct port alright, that is the high side. You don't want to connect to the high side. That coupling on the refill kit you have will only fit on the low side. Those fill ports are usually covered with a plastic cap that looks like a tire valve cap to keep dirt out. There are two lines that come off the AC compressor, follow those back until you find the valves, the low side is the valve your quick connect will fit on.

You found the high side port. The other line should have the low side and if it is not on there it might be at the AC evaporator which is a cylinder shape made of aluminum. The cap will have a L on it not a H. Do not force it on the high side.

Hi, the low side port is located on suction side near compressor , it can be identified as the larger of the two lines from compressor. Using eye protection and gloves hook can to hose, hook hose up to port , open valves, crank engine , turn on AC.

There are 2 ports, a low pressure and a high pressure port. The high pressure port is larger. Follow the lines coming from the compressor. One will lead you to the high pressure, the other will lead you to the low pressure port. You may need a tool similar to a tire valve core remover to unscrew the valve core a little bit so your connector can reach it to open the port and allow charging.

trace the pipe back from the firewall to the pump

Hi .. I just ran into the same problem .. I have a 2000 Expedition with the 5.4L engine .. the low side port is located on the passenger side of engine compartment just below the black metal bracket that contains electrical connections right in front of the firewall... you have to reach under this and locate the low side (larger line) and feel for the connection .. it is right in front of the accumulator .. There are two heater hose that hide the port .. you have reach under these to unscrew the port cap which is black .. you'll have to do this by feel .. I have found that you can by R134A charge with dye and leak sealant helps with small leaks .. if the system takes more than two cans be usre to add refrig. oil .. hope this helps

hello,good day,you have a 210 model with v 8 engine,your high pressure connection is located at front of your condenser,beside your ax.fan,then your low pressure connection is located at engine walling near your vacuum hose for brake booster,right side ,standing in front,ty

hi there,
commonly recharging port at low pressure is located at suction line of your ac system,on sample figure you can figure out recharging port.