Question about Dodge Cars & Trucks
Enter 97 dodge neon crank sensor in you tube. Videos there I just found. Good luck.
Posted on Jun 12, 2015
SOURCE: Cam Shaft Sensor Problems
Had the same problem before on my 04 Neon SXT...camshaft sensor is on left side of engine block, take out the battery and to the left of it (face car) is the camshaft position sensor. To change it you'll have to move a few hoses but its plan to see there on the left side of the engine...pretty easy remove and replace. Fixed my problem of car not going above 2k RPM when i replaced the sensor.
Posted on Dec 29, 2008
SOURCE: 2005 dodge noen cam sensor
I own a 2002 neon sxt and recently had to replace the cam sensor it should be in the same place.
look on the right side of the motor you should see it. it'll have a small wire harness that clips in the top and its fastend with 4 bolts. Oh and take the battery out before you do it it makes it a lot easier.
Hope this helps.
Posted on Feb 25, 2009
YOU NEED TO CHECK DARK GREEN/ORANGE WIRE AT IGNITION COIL WHEN CRANKING ENGINE FOR POWER..IF NO POWER,SHUTDOWN RELAY IS NOT BEING ENERGIZED..THIS ENGINE ALSO HAS CAMSHAFT POSITION SENSOR ON END OF CYLINDER HEAD..ENGINE CONTROLLER NEEDS CAM AND CRANK SIGNALS TO ENERGIZE THE SHUTDOWN RELAY..UNPLUG CRANK SENSOR AND CHECK VOLTAGE ON ORANGE WIRE..SHOULD HAVE APPROX 8V..IF NOT..UNPLUG CAM SENSOR AND SEE IF 8V SUPPLY RETURNS..IF NO POWER TRY UNPLUGGING VEHICLE SPEED SENSOR LOCATED IN TRANS HOUSING WHERE RIGHT SIDE AXLE COMES OUT OF TRANS..IF 8V RETURNS..THE SPEED SENSOR IS SHORTED INTERNALLY..THESE 3 SENSORS SHARE THE SAME 8V SUPPLY CIRCUIT..WITH SPEED SENSOR UNPLUGGED,PLUG CRANK SENSOR BACK IN AND TRY TO START ENGINE..HAVE SEEN THIS SAME PROBLEM AT WORK RECENTLY
Posted on Jul 19, 2009
Tips for a great answer:
Apr 29, 2016 | 1996 Dodge Neon
Feb 05, 2016 | 2001 Dodge Neon
Jun 11, 2015 | 1997 Dodge Neon
Oct 16, 2013 | 2003 Dodge Neon
Jan 03, 2011 | 1997 Dodge Neon
Feb 03, 2010 | 2004 Dodge Neon
Jul 18, 2009 | 1997 Dodge Neon
Oct 07, 2008 | 1999 Dodge Neon
86 people viewed this question
Usually answered in minutes!