Sport Utility Engine 4.4L V8 DOHC 32V 4Runner SR5. vehicle would not accelerate at all. After scanned the vehicle I got this error code P2118. How can I proceed with the diagnosis?
This is a fualure of the throttle valve actuator motor. fiollow the link for more inf on the code. https://www.autocodes.com/p2118_toyota.html
SOURCE: 2002 toyota 4runner with the engine,vsc off,vsc trac lights on
NEED TO HAVE COMPUTER CHECK FIND WHAT CODE MADE THE ENGINE KLIGHT COME ON.. AND HAVE IT FIXED,, VSC LIGHTS COME ON BECAUSE THE COMPUTER DEACTIVATES THE VSC AS A SAFETY FEATURE WHEN CK ENGINE LIGHT IS ON
SOURCE: overheating 1993 toyota 4runner sr5 v6
The V6's were known for blowing head gaskets. One of your engine cylinders is blowing hot air into the cooling system which of course then overheats the engine. I had the same problem and spent hundreds of dollars on a new water pump only to have the same overheating issue. I bought a $10 can of head / block sealer and followed the directions. Saved myself thousands of dollars in new head gasket repairs. The block sealer worked. No more overheating. Problem solved.
SOURCE: Toyota error code P2118
I don't have a Sienna but I do have a 2008 Toyota Camry SE. After it being in the garage for many months, 8 months I think, I had to give the battery a jump to finally start it up. Well The jumper cables I used weren't that great. They flickered and seemed to smoke a little. So i removed them and put a better set on to get a charge. I didn't think anything of it. After that charge came through and i was able to accelerate at all... The throttle was to the floor and the car would not even go up .5 RPMs... After several days and talking to the dealer, I was about to call a Tow to have it taken to the dealer. Luckily my friend came by with one of those diagnostic readers and it spit out the P2118 error code. Immediately we looked it up and found this site. Thanks to Fixya.com I was able to determine that it was a freakin measly fuse that blew due to bad jumper cables... Thank god for the Fuse and thank you to Fixya.com that I was able to determine this so quickly!!!
SOURCE: i have check engine light code po125---p1139
PO125 INSUFFICIENT COOLANT TEMPERATURE FOR CLOSED LOOP CONDITIONS.POSSIBLE CAUSES - LOW COOLANT LEVEL - STUCK OPEN THERMOSTAT OR FAULTY ENGINE COOLANT TEMPERATURE SENSOR. DID NOT SEE CODE P1139.
998 views
Usually answered in minutes!
×