How to deactivate atlarm system on a 1997 pontiactransport

It depends on how it was installed and who installed it .
In 97 almost no car companys had factory alarm systems .
You could go to the radio guy to get it installed .
Or get a do it your self kit of the shelves.
If you see a red wire hooked to the posivite battery termanil under the clamp disconnect it that will cut the power off to it .
If it was installed at a car electronics store .You will have to look around for it .Find the alarm horn follow the wires back to the electrical control unit look for a red wire larger then the other wires to the alarm . Their is always an inline fuse in the red wire some ware that can the replaced easly .Remove it and the alarm will be deactiveated and shouldn't casue anymore problems

I just had the same prblem. Reconnect your alarm first of all. You need to use your key bob "remote" to deactivate the alarm before starting. It is a feature "good one" i might add that should someone try to steal it the jeep will not start until u deactivate it w theke bob.

Sometimes the alarm box is under the dash on the drivers side. Did you try using the key to lock and unlock the driver side door? Some vehicles this will deactivate the alarm.

Might be the central locking system. Try using the key in the door (rather than the remote control) to deactivate the security system. Also make sure that the center console is completely closed (this is part of the central locking system).

first try another fob, then another ignition key. If none of these work then you need to find the alarm controle module some where under the dash by the steering colume. once you have located the controle module trace the wires usally a red with block stripe back to where it is tee tapped to the wires of the ignition switch. unplugging the tee tapp should allow you to start the vehicle. but the alarm will be deactivated

NOTE: No synchronization required after battery replacement.
How - 1996

NOTE: Remote control contains a transponder and MUST be attached to the same ring as the ignition key.
Unlock the vehicle using the key. Deactivate alarm.
NOTE: Alarm system can be disarmed using 4 digit code from vehicle security card as detailed in the owner's handbook.
Switch ignition ON. Switch ignition OFF. Remove ignition key. If battery replacement has taken longer than 5 minutes: Deactivate the system using 4 digit code from vehicle security card as detailed in the owner's handbook. Hold the remote control close to the vehicle. Press either button of the remote control 4 times or more in quick succession.

The alarm system will deactive the fuel injectors if it thinks its being stolen

you cant dealer only

you have to call tyota and thet have to send you a new computer

if the car only has a factory system, then you only need to insert the key to unlock the door to turn the alarm off. There should be a red light on the door panel that blinks and that should show you it's off, not sure try turning the key on the door twice. If it's aftermarket, get a replacement unit.