Question about 1999 Daewoo Lanos

1 Answer

Please show me a picture that shows the position of oxygen sensor on a daewoo lanos 1999 model 1.6 litre

Posted by walter makeredza on

Ad

1 Answer

Thomas Perkins

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Daewoo Master
  • 14,869 Answers

Oxygen Sensor

1999 Daewoo Lanos 1.6L MFI DOHC 4cyl

The Oxygen Sensor is located: Under hood, driver side, lower engine area, above exhaust pipe flange, mounted in exhaust manifold,don't have a picture.Here's a link to what it look's like just remove the electrical connector,get a open end wrench and remove.. http://www.autozone.com/engine-management/oxygen-sensor/bosch-oxygen-sensor/daewoo/lanos/1999/4-cylinders-6-1-6l-mfi-dohc/4971_102074_1784_97999

Posted on May 25, 2015

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My daewoo lanos 1999 model can start and drive it has no power if you try to accelaret the car then cut off or just reduce the speed whats the problem


Walter: The most common cause of acceleration issues lies in the transmission. However, 2CarPros.com suggests:
Inspect and test all the following:

Oxygen sensor.
Catalytic converter.
Fuel injectors dirty/sticking.
Mass airflow sensor/Airflow meter.
Throttle position sensor.
Manifold absolute pressure sensor.
EGR Valve
Fuel pressure regulator leaking or defective fuel pump.
False air leakage.
Fuel contamination.
Foul/defective spark plugs.
Open spark plug wires.
Ignition coil/Coil packs defective.
Incorrect ignition timing.
Cap and rotor.

May 25, 2015 | 1999 Daewoo Lanos

1 Answer

WHAT DOES daewoo p0342 IMPLY?


code p0342 refers to camshaft position sensor(CMP) sensor A bank 1 --low input== causes wiring short to ground--CMP sensor--ECM
check wiring and connections , replace the position sensor

Aug 12, 2014 | 1999 Daewoo Lanos

1 Answer

I have a daewoo cielo 1996 model. My car is giving out black smoke from the exhaust and it smells like rich mixture.(more of petrol less of air) The onboard diagnostic shows code 13 and 44. where could the...


Make the FixYa experience better for everyone by voting.

Hi,

The Code 13 refers to the camshaft position sensor and should be fixed ASAP since it can cause the engine to shut down without warning, You can replace the unit in under thirty minutes. Plan on paying about $50 for the part on eBay or Amazon.

The replacement should clear up the P0044 HO2S Heater Control Circuit High (Bank 1 Sensor 3) reading.

All the best,

Ben

Oct 01, 2011 | 1999 Daewoo Lanos

1 Answer

How do you replace a oxygen sensor?


For 2000 Daewoo Lanos 1.6L MFI DOHC 4cyl the Oxygen Sensor is located under vehicle, driver side, below seating area, mounted in exhaust pipe in front of catalytic converter.

Good luck (remember rated this).

Jul 22, 2010 | 2000 Daewoo Lanos

1 Answer

Excessive consumption of fuel of daewoo matiz and cutting off


Sounds like the Oxygen sensor in the exhaust may not be working effectively. Check the connections and wiring running to it. The Oxygen sensor only starts to work when hot so be careful. The sensor outputs a pulse of voltage when the engine is running. If the voltage output is steady then it needs replacing.

May 28, 2010 | 1999 Daewoo Lanos

1 Answer

I just get a 2000 lanos but the check engine ligth is ON when i put it the code reader says to me 2 codes : 1st code is P0137 and p1336 say a lot lf items but got to be only one of those , whath can be???...


Essentially the same as P0136, P0137 refers to the second oxygen sensor on Bank 1. P0137 means the O2 oxygen sensor's voltage remained low for longer than 2 minutes. This, is interpreted by the ECM as a low voltage condition and sets the MIL. Bank 1 Sensor 2 is located to the rear of the catalytic converter and should produce an output signal relative to oxygen storage capacity of the catalytic converter. This rear (sensor 2) sensor is less active than the signal produced by the front sensor. However, if the ECM senses the sensor is inactive, this code will set.

Symptoms There may be no visible symptoms to the driver, other than the MIL (Check Engine / Service Engine Soon) illumination.

Causes
A code P0137 may mean that one or more of the following has happened:
  • Faulty O2 sensor Exhaust leak near the rear sensor
  • Plugged catalyst
  • Short to voltage on O2 signal circuit
  • High resistance or open on O2 signal circuit

  • Possible Solutions
  • Replace faulty sensor
  • Repair exhaust leak near the rear sensor
  • Check for restriction in catalyst and replace as necessary
  • Repair short, open, or high resistance on o2 signal circuit
The other code is your crankshaft position sensor. You need to replace both of the sensors and the check engine light will go off.

Sep 28, 2009 | 1999 Daewoo Lanos

1 Answer

July 2001 1.4SE DAEWOO LANOS


214 is out of spec ,it will not pass an inspection here in spain thats for sure .Must be lower than 2 .Only soloution i know off is to change the cat and the oxygen sensor ,and not forgotting to take the air filter out for the test

Apr 06, 2009 | 2001 Daewoo Lanos

1 Answer

Location of the Throttle Position Sensor on a 1999 Saewoo Lanos ?


Sir,
Check this link. It applicable to all models.
Thanks Good Luck
Appreciate to rate as "Fixya"

Mar 10, 2009 | 1999 Daewoo Lanos

Not finding what you are looking for?
1999 Daewoo Lanos Logo

458 views

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

john h

Level 3 Expert

23911 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14869 Answers

xxxxxx xxx

Level 3 Expert

5023 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...