Question about 2001 Dodge Grand Caravan

Coolin fan is not working what could be the problem

1 Answer

kirtec auto

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.
Dodge Master
1,348 Answers

Run the fan with 12 volts.does it work? if yes then check,the fan relay,fuse,coolant fan switch,and .....if the fan does not work with 12 volts,the fan is no good

Posted on Jul 11, 2009

Add Your Answer

Upload

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

1 Answer

Cooling fan relays 2008 pt cruiser

The cooling fan relays are under the hood in the fuse and relay center.

Dec 03, 2016 | Chrysler PT Cruiser Cars & Trucks

1 Answer

My coolin fan wont come on wat should I do

Cooling fan is controlled by a relay and a temp sensor. You need to check that each piece is working.
Run power to the fan. fan run? fan ok.
Bridge the relay. Fan run? run power to the relay coil. Fan run? relay good.
find temp sensor. replace.

May 29, 2015 | Cars & Trucks

2 Answers

I replace my coolin fan on my m-benx c300 and it still do not work, what could it be???

Fan relay or thermo switch. Those fans draw huge amperage starting up so they heed to ge activatd by an electrical relay, most likely in fuse box

Jun 25, 2014 | Cars & Trucks

1 Answer

2006 yukon denali engine overheat. fans are working good. no stream, no leakage

check your thermostat

Jan 20, 2014 | 2006 GMC Yukon Denali

1 Answer

My car overheated and cooling fans not turning on

therr are two cheap sensors for both the coolin &AC fans,( i had same problem) take the wires off of one switch at a time while car is runnin & put jumper on wires n tie them together, if fan cmes on switch is no good

Nov 13, 2012 | 1995 Honda Accord

1 Answer

Were is tha fuse box located in a 2006 dodge magnum..my coolin fan stop working

Under Hood...

Sep 14, 2011 | Dodge Magnum Cars & Trucks

1 Answer

My coolin fan doesn't kkick on when the engine heats up an my car wants to shut off what can be the problem?

Bad relay to fans usually causes this and if computer is shutting it down over heating issues then means it's reading correctly from the coolant temperature switch meaning that's working. Given that the computer wants to shut it down and knows it's hot should mean it's sending the signal for the fans but no results because relay. Easier to determine if you have twin fans because if the fan motor was bad only one would not work.

Sep 02, 2010 | 1991 Audi 90

1 Answer

Front heating and coolin fan only works on speeds 3, 4, and 5.

there is a relay behind the glove box, replace that and all speeds will work again

Jun 22, 2010 | 2003 Chevrolet Tahoe

2 Answers

On my 2000 Jimmy when I'm at low speeds in the city it usually blows quite warm out of the heater (not always). But suddenly it will quit blowing any heat at all. On the highway it just blows cold. The...

Hello. First, it is probably that the clotch in the coolin fan isn't working. When the coolin fluid is warm, the temperatur put it in work, and the fan works rapidly, when the temperatur lows, the clotch loose the fan an is waiting the warm up again. But your Jimmy don't have the coolin fan in the principal belt, it have an electric coolin fan. In that case, your problen is for a low level of coolin water, or the relays of the electric fan don't work properly.
Finaly, my english isn't good, because I speak in spanish, but if my bad english solves your problem, i'm geting so well. I working every day in electronics cars, and that is the basic metod of analyse that I use.

Dec 21, 2009 | 2000 GMC Jimmy

2 Answers