My acura 1996 tl 3.2 gear is stuck in neural. What do I do?

Marvin

• 85242 Answers
• Posted on Feb 28, 2009

SOURCE: Where is the starter located on a 1996 Acura 2.5 TL?

it is at the rear bottom of engine, points inside the bell housing of the transmission, u will need to jack the car off the ground to see it and get at it for repAIR

SOURCE: How to program the keyless entry for my 1996 Acura TL.

Hi, Stacie,

here's the instructions for a 97 TL - I hope they're the same.

Note:
Entering the programming mode cancels all learned keyless remotes, so
none of the previously programmed remotes will work. You must reprogram
all of the keyless remotes once you are in the programming mode.
You must complete each step within 4 seconds of the previous step to keep
the system from exiting the programming mode. You must program remotes
within 10 seconds of each other
1. Turn ignition switch to ON (II)
2. Within 4 seconds press the LOCK or UNOCK button on one of the remotes.
(An unprogrammed remote can be used for this step.)
3. Within 4 seconds turn ignition switch to LOCK (0) position
4. Within 4 seconds turn the ignition switch to ON (II)
5. Repeat steps 2, 3 and 4 two more times using the same keyless remote
used in step 2
6. Within 4 seconds press the LOCK or UNLOCK button on the same remote.
Make sure the power door locks cycle to confirm you are in programming
mode.
7. Within 10 seconds press the LOCK or UNLOCK button on same remote.

8. Within 10 seconds press the LOCK or UNLOCK button on all other
remotes you want to program. Make sure door locks cycle after you push
each remote button to confirm system has accepted the remote.
9. Turn the igniton switch to LOCK (0) to exit programming mode.
10. Test remote(s)

Hope this helps :)

John

ROBERT GARCIA

• 926 Answers
• Posted on Apr 17, 2009

SOURCE: how to replace a fuel pump on a 1996 acura tl

in trunk , behind the rear passenger seat look for a metal cap aprox 6in roud

SOURCE: Where is the starter on a 1996 Acura 3.2 TL? On a

grantgga2: I don't think this is one you are going to want to try to change out.
It entails having to remove the left axle and part of the exhaust pipe to gain access to the starter. At that point, you have one bolt which goes in at the bottom from the starter side and bolts to the engine. The other bolt passes through the trans axle housing and bolts into the starter, pulling it up to the engine.
SCARED YA HUH? I'D SAY FROM A 1-10 FOR A WEEK END WARRIOR, IT WOULD BE ABOUT A 6.
Was I helpful?

SOURCE: ABS light on

This means that the abs is not working. The brakes will still work just without the anti lock feature. Check your fuses then check the connections at each of the brakes, when ever I have had the abs light stay on a connection had came loose.