How to remove transmission from a 1997 chevy suburban 4x4

Dennis Mulford

• 1055 Answers
• Posted on Feb 25, 2009

SOURCE: 1993 chevy suburban 1500 4x4 transmission enterchange list

cheaper ,faster and eaiser too just replace it,200.00-400.00 at a bone yard 1200.00-2300.00 too rebuild
a lot of years interchange with it best too pull it and match it up

SOURCE: i need to replace my idler arm and pitman arm on

you will have to remove the steering gear box to change the pitman arm. the idler arm is on the other side by the passenger wheel. one nut and two bolts going threw fender take it off.

SOURCE: remove a power steering pump out of a 97 chevy suburban

For step by step instruction, you best pick up the auto repair guide.
Steering pumps, in general, are not very difficult to replace. Pay careful attention to how you take it apart. Use a camera to help you remember how things go.
You will need to remove the drive belt...it rotates all the accessory pulleys, including the steering pump.
The pump should only have two or three bolts holding it on. Make sure you have a hose clamp, or something clean, to catch the steering fluid when you remove the hose.
Make sure not to over or under tighten the hose clamps when reinstalling it. Start snug...then check for leaks, and tighten if needed.
Good Luck.

SOURCE: how to replace the gear box on a 1997 k1500 4x4

remove the p/s lines to the gear box, take the nut of the pitman arm and seperate the center link of the pitman arm, remove the front shield, remove three bolts from the side of the frame holding the gear box onto the frame, you will need a puller to remove the pitman arm off the gearbox, reverse procedure to install. add fluid.

SOURCE: will a 1990 chevy 1500

yes it will as long as it is the same model transmission. As long as you get a transmission out of a standard cab truck you should be ok. ( for a good idea Most 88-98 gm trucks, full size blazers,jimmys,tahoes, and yukons will interchange) same chassis just different bodys and emblems