SOURCE: Rear seat removal 2000 merc Villager
fold top seat down first
then there is seat clip push seat forward with upward motion
this releases back floor clamps once released pull seat back this releases the front clamps then pull seat out of back door
SOURCE: Brake Rotor Replacement Ford Escort 1997
The rotor is not held on by the big nut, it slides on and off, only the wheel holds it on, the clearance between the rotor and the front hub which the large nut holds on is very small, rust forms and the rotor gets stuck, use a hammer or a large piece of wood if you plan to reuse the rotor and hit it from side to side, spray penetrating oil to loosen the rust, it is a bugger but it will come loose, then make sure to wire brush all the rust off or wheel retention may be compromised.
SOURCE: Mercury Villager headlight assembly diagaram for removal
This is easy. Lift the lid open. Look at the back of the sealed beam and you will see a clip and an o ring. Pull the clip up and pull wires back toward the driver's seat. Unscrew the o ring and firmly pull the bulb out toward the driver again. Note the 3 tabs on the bulb seat and realign the new bulb with those tab ( 2 bottom, 1 top). Replace with #9007 bulbs..do them both.
SOURCE: I need to remove the front rotors
here's a good instructional video on replacing the rotors... any more information you need feel free to ask.
http://www.monkeysee.com/play/11914-how-to-replace-brakes-brake-pads-and-rotors
Please take a moment to rate this solution.. thanks
SOURCE: Alternator Removal
Alternator - REMOVAL & INSTALLATION
Fig. Alternator wire identification
Hope help with this (remember rated this post).
63 views
Usually answered in minutes!
×