Question about 1998 Oldsmobile Intrigue

1 Answer

How do I get the wire back on track, on my driver side window, in a 98 Oldsmobile intrigue

Posted by ken more on

Ad

1 Answer

Jeff Armer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Oldsmobile Master
  • 15,575 Answers

You need a new regulator ! it's broken

Posted on May 08, 2015

Ad

3 Related Answers

Anonymous

  • 4 Answers

SOURCE: 2001 oldsmobile alero window off track,

first remove the door panel there are three screws that need to be removed first 2 under the inside door handle and 1 on the lower left hand side behind a reflector then pull off the panel it will be held on by push clips, once inside move the plastic weather bearrer to the side ,run the window half way down you should see 2 window holding brackets pull the window up so you can drop it in the brackets, first get some black window adhesive fill the brackets with adhesive put window in brackets and roll it up and leave it up for 24 hrs.If the brackets are broken you will have to replace the whole window motor assemly which you can get on line for 89.00 not the 250.00 at dealer and you can install it yourself its easy to do.

Posted on Mar 05, 2009

Ad

Anonymous

  • 18 Answers

SOURCE: My driver side window will not roll back up

You need to remove the door panel and make sure you are geting power to the window motor.The best way to do this is to use a test light and loop the test light in the window motor connector with it unplugged from the motor and work the switch up and down.If the test light lights up in both directions the motor needs to be replaced.You should also inspect the regulator for damage.If the test light does not light in one or either direction you may have a bad switch.

Posted on Aug 07, 2009

super_guy

  • 1986 Answers

SOURCE: i have an 1998 Oldsmobile

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then pull back the weather seal and you will be able to put it back on the track. You will most likely need to buy some clips to secure it back on

Posted on Oct 21, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need car wiring diagram for a 2002 oldsmobile intrigue GL


PARTS STORES HAVE REPAIR MANUELS W/WIRE HARNESSES

Jan 13, 2013 | Cars & Trucks

1 Answer

I think my drivers side power window is off track, after taking door panel off how would I be able to tell, by looking, if the window is indeed off track?


After removing the panel you will be able to see the inner door parts. You can move the glass until both wheels are inside the track.

Mar 17, 2011 | 2000 Oldsmobile Intrigue

1 Answer

When i turn my 98 intrigue on sometimes the lights only on the driver side, the lihjts on the dash, and my daytime lights blink on and off. wat could b the problem??


sounds like a ground problem i would check all the wiring for the abs censors as well i know my daytime running lights and my panel functions all stop at once it was the abs censor at the drives side wheel. hope this helps

Feb 23, 2011 | 1998 Oldsmobile Intrigue

1 Answer

Electric windows on my '98 Olds Intrigue don't work. What are the most likely reasons for this malfunction? I have no idea where to start.... Thank you.


Check inside the drivers door,where the wires go to the body.
Have so slice a **** in the rubber boot to see the wires.
Often from the drivers door being opened and closed the most,the wires at that point will break,if it's the feed wire none of the windows will work.Kinda tight there but you can repair them with a crimp connector.

Oct 21, 2010 | 1998 Oldsmobile Intrigue

1 Answer

Rear power window drive cable


hello there:
i think that you may want to go ahead and replace the actuator and motor this would solve the problem and keep from having troubles later on down the road it should come with the track cables and all i hope this helps you out ..... if you would please leave a review for me thanks sincerely D.Jones

May 30, 2010 | 2000 Oldsmobile Intrigue

2 Answers

Window on drivers side won't go up or down how do I take the panel off to see if off track?


do you here any noise like its making a attemp? if not i think its broken wires right where the door opens, seen it many times

Apr 09, 2010 | 2000 Oldsmobile Intrigue

1 Answer

I have an 1998 Oldsmobile Intrigue and the driver side window is off track, how do i put it back on track?


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then pull back the weather seal and you will be able to put it back on the track. You will most likely need to buy some clips to secure it back on

Oct 21, 2009 | 1998 Oldsmobile Intrigue

1 Answer

My driver side window will not roll back up


You need to remove the door panel and make sure you are geting power to the window motor.The best way to do this is to use a test light and loop the test light in the window motor connector with it unplugged from the motor and work the switch up and down.If the test light lights up in both directions the motor needs to be replaced.You should also inspect the regulator for damage.If the test light does not light in one or either direction you may have a bad switch.

Aug 06, 2009 | 1998 Oldsmobile Intrigue

Not finding what you are looking for?
1998 Oldsmobile Intrigue Logo

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Joe Taylor
Joe Taylor

Level 3 Expert

2228 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...