Check this link out Cindy. 1996 jeep grand cherokee limited what fuse works sunroof
SOURCE: 1996 Jeep Grand Cherokee wiper arm
The little blade lock will lift up. see image..."http://econtent.autozone.com:24991/znetrgs/repair_guide_content/en_us/images//0900c152/80/0a/9d/4c//medium/0900c152800a9d4c.gif"
SOURCE: where is the fuse for the tail lights for jeep '96 grand cherokee
Unfortunately, could not find owners manual for 1996.
Website only has models 2004-current
=> http://www.jeep.com/en/owners/manuals/index.html
There are two fuse boxes. One under driver compartment usually left to the steering colum. A label is stamp to identify each fuse. I would look at Park Lights and Instrument Cluster fuses. The easy way is to take a flashlight and look at all fuses. If they are all okay. Then just remove the Park Lights and Instrument Cluster fuse and reseat them. The other fuse box is under the hood and near the batter. It also has a label to identify each fuse.
SOURCE: heated seat 1996 jeep grand cherokee
C1 & C2 in your panel are most likely one of the culprits, if no power at heater at seat. Sounds like testing for power at seat switch is easier to do than get at these circuit breakers in the panel. If you have power at switch at seat, then it's not the fuse/circuit breaker. Good reading at this link for you.
http://www.wjjeeps.com/seats/seats.htm#HEATED
SOURCE: LOCATION OF LIGHTER FUSE FOR 1996 JEEP GRAND
If you have the owner's manual look up fuses in the index, good illustration. If you don't, I do. It shows a relay and a 15 amp fuse. Look at the passenger kick panel, pull the cover, and it is #2 fuse (second from the top on the left) The see the relay you may have to pull the panel (two screws and a clip) the relay is the third cavity down, third row from the firewal side.
Let me know if this works for you?
SOURCE: IAC Valve Location - 1996 Jeep Grand Cherokee
The idle air control valve is located on the back of the throttle body. It has an oval electrical connector and two torx screws holding it in. Unplug the connector, remove the two screws then lightly tap the body with a soft faced mallet to loosen it from the body.
Once you have it out and prior to installing a new valve clean the seat inside the throttle body where the idle control fits. This must be very clean! Installation is in the reverse order.
To save some cash, pull the valve out and clean it with throttle body cleaner, this usually fixes the problem for quite a while.
Good luck and hope this helps.
653 views
Usually answered in minutes!
×