How do you turn the fuel pump shut off button back on a 99 Ford windstar

SOURCE: remove fuel pump from tank ford windstar 98

To gain access to the fuel pump, it is necessary to remove the fuel tank.

1. Depressurize the fuel system and remove the fuel tank from the vehicle.
2. Remove any dirt that has accumulated around the fuel pump module attaching flange, to prevent it from entering the tank during service.
3. Turn the fuel pump module locking ring counterclockwise using a locking ring removal tool or a brass drift and remove the locking ring.
4. Remove the fuel pump module.
5. Remove the seal gasket and discard it.

1. Put a light coating of grease on a new seal ring to hold it in place during assembly. Install it in fuel tank ring groove.
2. Insert the fuel pump module into the fuel tank, then secure it in place with the locking ring. Tighten the ring until secure.
3. Install the tank in the vehicle.
4. Install a minimum of 10 gallons of fuel and check for leaks.
5. Install a pressure gauge on the throttle body valve and turn the ignition ON for 3 seconds. Turn the key OFF , then repeat the key cycle five to ten times until the pressure gauge shows at least 30 psi.
6. Check for fuel leaks at the fittings.
7. Remove the pressure gauge.
8. Start the engine and check for fuel leaks.

SOURCE: fue pump location 2001 ford windstar

Probaly in the fuel tank

SOURCE: 1998 ford windstar will start, but won't turn

if car has solonoid mounted under hood, then ,jump from baterry cable on solinoid, to ignition wire or post. if van works then solinoid is bad,,

Testimonial: "thanks for taking the time to answer my question! we have already spent $$$ on repairs so your advice will definitely help us troubleshoot!"

SOURCE: 2000 ford windstar hard to start sometimes it will

Could be many things wrong at once.
Check your fuel pressure first, then check your spark plugs for spark, check your system for vacum leak.

SOURCE: 99 Ford Windstar. Not getting any power to the fuel pump

first check the fuse if it is good then check for power at the relay