How do I replace the horn on a Lincoln Navigator 2001 model???

SOURCE: 2001 Lincoln Navigator

you can replace the bags. with springs from a navigator that did not come with air ride. a salvage yard should help you out. good luck

SOURCE: Lower Ball Joint Removal and Replacement

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152801edd39

SOURCE: 1998 Lincoln Navigator rear wiper motor

First remove outer wiper ,take off plastic guard there is a bolt underneath it remve wiper thenremove 2 screws that hold grab handle on inside of rear door.remove 2 plastic push tabs with removal tool.pry plastic cover off carefully removing push tabs with removal tool or flat blade screwdriver about 10 of them if I remember correctly pull bottom half of cover out of each conection and lift off at center. peel plastic from gate carefully as you have to put it back on.this exposes the motor disconnect grey plug to wiper motor ,three 8 mm screws hold motor to tailgate best of luck

Marvin

• 85242 Answers
• Posted on Mar 24, 2009

SOURCE: I have a 2001 lincoln Navigator The overdrive kept flashing

one question at a time, the OD flashes to let u know that the transmission control module has detected a fault in the trans, this is useualy slipping, u may not even feel it. Have it tested for trouble codes.
As for the AC, is the system fully charged, does the compressor run?

Duane Wong

• 6826 Answers
• Posted on Oct 29, 2010

SOURCE: how do you replace fuel pump in lincoln navigator

Fuel Pump Module Removal & Installation To Remove:
WARNING
Highly flammable mixtures are always present in any fuel related component. Smoking or carrying lighted tobacco or an open flame of any type may ignite the flammable mixtures.
WARNING
Even when the engine is not running, fuel in the fuel system remains under high pressure. Fuel system pressure must be relieved before working on or disconnecting any of the fuel lines, fuel tubes, or fuel system components. Failure to do so may result in accidental spraying of fuel, personal injury, or a fire hazard.

1. Remove Fuel Tank. Fuel Pump
   
   
2. Remove fuel pump lock ring.
3. Remove fuel pump.
4. Remove and discard fuel pump O-ring.

1. Install new fuel pump O-ring.
2. Install fuel pump.
3. Install fuel pump lock ring. Tighten to 66 ft-lb (89 Nm).
4. Install Fuel Tank.