2011 Toyota Sienna. I found that the hose feeding from the brake booster is not producing a steady stream of air, but is cyclical in direct correlation with the RPM of the vehicle. I am trying to identify the part for this, so I can research it to see if it needs to be replaced.

SOURCE: 2002 Toyota Sienna cabin air filter??

Unfortunately, no.
Toyota began installing the cabin air filters in the Sienna product starting in 2003.

SOURCE: The sliding door handles of my 1998 Toyota Sienna have both broken.

I replaced both of my sliding door handles this weekend. It was actually pretty easy. Cheapest I could find the handles was a little over $70 each. The interior panel is held on with one screw and 10 nylon clips. The one screw is in the cup holder. Put you hand in the cup holder and push out at the bottom. It pops right off exposing the one screw. I started on the clips from the top at a corner. Seemed to be the easiest place to slide a screw driver under. Once I got the screw driver in, I started working my fingers under the panel. The clips run mostly along the top and bottom about 6 inches from the edge. I made an effort to apply the force as close to the clips as I could to reduce flexing the panel. Once I got the first clip to pop out the other followed pretty easy and the panel lifted right off. Carefully peel back the plastic barrier. The exterior handle is held on with two 10mm bolts. Connecting the short cable was pretty obvious once you could see everything. Now I have to teach everyone to open the side doors very gently! Hope this helps.

SOURCE: How do I replace the Rear Brake light bulb of 2001 Toyota Sienna?

I have a 2001 Sienna and have had to replace most of my tail light bulbs.

The bulbs that are mounted in the fender (wrap arounds) have acess panels in the van's interior that easily pop out and expose the back of the light assembly.

However, the bulbs that are found in the lift gate are a different matter. You have to remove the whole interior panel to the lift gate to expose the light assemblies. Go to your auto parts store and get a tool to help pop out the plastic retainers from the lift gates metal frame. Don't force the retainers out. Go slowly and gently so that you don't damage the interior panel. If you are really gentle you might even get to reuse the retainers.

Good luck!

SOURCE: Replacing RH Side view mirror on a 2006 Toyota Sienna

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Tony

• 23 Answers
• Posted on Mar 10, 2010

SOURCE: replace toyota sienna brake light

If you are talking about the High Brake Light at the top of the tailgate:

1.) Take out the two Phillips head screws in the lens.
2.) Carefully pry the lens straight back . The gasket sticks to the paint so be careful not to rip the foam gasket.
3.) The bulb is a 921 replacement. Easily found size.

If you're talking about the brake light in the tail light assembly:

The instructions for accessing the tail light are in the Owners Manual. Basically, you have to remove one or two screw/bolts from the inside of the vehicle, then there are two snap type plastic hole/receptacle in the plastic tail light assembly. Be very careful that you pry on the housing in the proper direction, perpendicular to the entry of the snap in connector, or you will break the plastic bayonet or attachment to the lens assembly.

It sounds harder than it really is once you take a look at it. If you have a manual, it will tell you and show you how to get the rear tail lights off easily without breaking any of the plastic connectors. Hope this helps.