Question about 1985 Toyota Celica

Open Question

How do I adjust the automatic choke on a 1985 toyota celica

Posted by Timbree Knowles on

Ad

5 Related Answers

Anonymous

  • 1 Answer

SOURCE: 1985 convertible celica fuse location

Check the harness connections located inside r-rear trunk panel. You will find power top motor & wire harness there.

Posted on Nov 03, 2008

Ad

Anonymous

  • 2 Answers

SOURCE: 85 Toyota Celica GT Headlights problem

There is a knob beside the headlights under the hood, fairly good sized, looks like rubber and you can manually turn down your headlights. That happened to my 86 Supra last year and the sync was just off and once I turned them down they started working perfectly. Hope this helps

Posted on Apr 04, 2009

Ad

Anonymous

  • 2 Answers

SOURCE: i need to locate the ecm on my 1985 toyota celica

the ecm is in the glove box

Posted on May 08, 2009

emissionwiz

Marvin

  • 85239 Answers

SOURCE: How do I remove an 1985 toyota celica supra

remove the horn pad, it is held on by a few screws recessed at the back of the steering wheel spokes, then go to Kragen and buy a unniversal steering wheel puller, easy to use, it wioll pop the wheel right off.

Posted on Aug 30, 2009

jturcotte

Jeffrey Turcotte

  • 8991 Answers

SOURCE: how do u bleed the clutch on a 1985 toyota celica

See instructions below from autozone.com. If the clutch still has air after following this procedure, try back bleeding by pushing the slave piston in while the bleeder is open, then closing bleeder before releasing the piston. This is similar to bench bleeding the slave, in case you didn't do that before the installation.


HYDRAULIC SYSTEM BLEEDING This operation must be performed any time the clutch master or slave cylinder has been removed or if any of the hydraulic lines have been opened.

WARNING Do not spill brake fluid on the bodywork of the vehicle; it will destroy the paint. If fluid is spilled, immediately wash the surface with plenty of clean water.

  1. Fill the master cylinder reservoir with brake fluid.
  2. Remove the cap on the bleeder screw on the clutch slave cylinder. Install a clear vinyl hose on the fitting; place the other end submerged in a clear glass jar partially filled with brake fluid.
  3. Have an assistant pump the clutch pedal slowly several times. After several pumps, hold the pedal down and open the bleeder, allowing fluid to flow into the jar. Close the bleeder valve almost immediately after opening it. Release the pedal only after the bleeder is closed.
  4. Repeat the process until the fluid in the hose contains no air bubbles. tube. When there are no more air bubbles in the system, tighten the plug fully with the pedal depressed. Replace the plastic cap.
  5. Fill the clutch master cylinder reservoir to the correct level with brake fluid.
  6. Check the system for leaks.

Posted on Nov 02, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1985toyota celica gt22rengine valve adjustment

You need a feeler gauge and a socket on the Crank. Rotate until the Lash is out of the Cam (NOT LIFTED and install the Feeler Gauge and loosen and then tighten to be within spec. You will need to rotate the engine a few times and keep track of the ones you do.
1helpful
1answer

What kind of engine does a 1985 toyota celica gts have? And what cars or trucks have that same engine????

Hi, you have the 22R-E engine. This engine was also used in the pick-up and 4-runner. You can read more here:
http://en.wikipedia.org/wiki/Toyota_R_engine#22R
0helpful
1answer
0helpful
1answer

1985 Nissan 720 ext. cab pickup problem

You need to adjust the automatic choke. Your choke may not be opening fully. There is a fast idle cam linked to the choke to keep the throttle open more until the engine is warm. The idle mixture screw is part 37 in the picture, but get the choke adjusted right first, and you may not have to adjust the mixture screw. See adjustment procedures at link beloe.


0900c1528004f50a-lgd0on5kwttmxgdtmabjr2fz-1-0.gif
Repair Guides Carbureted Fuel System Carburetor AutoZone com
0helpful
1answer

Need to locate fuel filter on 1985 Celica GTS 4cyl.

From autozone.com (repair info section) for a Celica with a 2.4L engine ...Under hood, center, upper firewall, mounted in fuel line
0helpful
1answer

94 celica starting problem

check your engine timing
2helpful
2answers

85 Toyota Celica GT Headlights problem

Bad headlight switch or relay, or shorted wire. I would check the relay first.
0helpful
1answer

1985 convertible celica fuse location

Check the harness connections located inside r-rear trunk panel. You will find power top motor & wire harness there.
Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8991 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6963 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15008 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...