There are 3 vertical rows, which row and how many from the top is it and what amp?
Go to you tube type it in ok
The fuse box for your vehicle is located in the left lower panel by drivers feet. here is a video showing how. 2002 - 2005 should be the same.
Interior Fuse Box Location 2002 2005 Kia Sedona 2003 Kia Sedona EX 3 5L V6
Most vehicles have the fuses listed in the owners manual in the glove box or buy you a service manual from a parts supplier like Advance, Oreily's etc. .
SOURCE: where is the crank position sensor located in 2005
Hello martinezmelm: My name is Roger and I can answer your question. To locate the crankshaft position sensor. You will need to remove the timing cover. You will find the sensor on top of the crankshaft gear. Between the V of the timing belt.
Should you need further help please just ask. Please rate the answer as this way I know it was helpful. Thank You for using Fix Ya. Roger
SOURCE: where is the fuse located for the windshield washer motor
Hello and Welcome to Fixya
The fuse is in the engine compartment fuse box. See diagram in the owners manual section 6-11..to find out which one it is, or read the list (provided with amp labeling) on the inside cover to review the fuses there.
Locate the windshield washer fuse accordingly and replace it with the same labeled new fuse.
Do RATE my solution, If this helps you out.
Regards.
Testimonial: "thanks"
SOURCE: Location of the crankshaft position sensor on a
At the front of the crankshaft. if its near time for the timing belt, you want to replace it along with any pullies, tensioner and water pump
SOURCE: where is the crankshaft position/crank
Hi, at the front of the crankshaft. if its near time for the timing belt, you want to replace it along with any pullies, tensioner and water pump
The crankshaft position sensor is mounted on the engine near the crankshaft.
Operation
The crankshaft position sensor is a Hall-Effect sensor that senses the crank angle (piston position) of each cylinder and converts it into a pulse signal. The signal from the sensor is relayed to the ECM to indicate engine rpm and the position of the crankshaft.
Removal & Installation
Temperature - 4°F, test specification 1500-1700 RPM Temperature 32°F, test specification 1350-1550 RPM Temperature 68°F, test specification 1200-1400 RPMTemperature 104°F, test specification 1000-1200 RPM Temperature 176°F, test specification 650-850 RPM
813 views
Usually answered in minutes!
×