I've got a 99 ford crown vic and the doors will unlock but not lock back

SOURCE: how do I remove the inner door panel on a 96 ford crown vic without damage?

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

SOURCE: 1999 FORD CROWN VIC. 4.6 - PROBLEM, NOISE

This is caused by the IAC valve. Over time the valve becomes gummy and inoperative. Get it replaced and the problem is solved. IAC stands for idle air control, hence the stalling concern.

Posted on Oct 18, 2009

Ronny Bennett Sr.

• 6927 Answers

SOURCE: ODOMATOR IS NOT WORKUNG 1996 FORD CROWN VIC

The speed sensor in the transmission is most likely the problem.

Posted on Nov 26, 2009

warlock61

• 659 Answers

SOURCE: lock module for 2001 ford crown vic

it is located in the drivers door

Posted on Aug 12, 2010

SOURCE: My 99 Crown Vic acts like it isn't getting gas

Was the fuel tank drained and flushed when the fuel pump was replaced? By this time it will have collected a lot of junk and gunk. Without cleaning the tank, the fuel pump will simply clog and stop working again.

Posted on Oct 06, 2012