Question about 1997 Mercury Mountaineer

Open Question

My 1997 mercury mountaineer windows won't go up and down

My windows won't go up and down

Posted by Anonymous on

Ad

5 Related Answers

Anonymous

  • 92 Answers

SOURCE: 1997 Mercury Mountaineer

if the engine is a 4.6L the pcv will be on top and in middle of pass side valve cover.pull to remove.
if the engine is a 4.0L the pcv is located at the rear(firewall) of drivers side valve cover.this pcv has lock tabs holding it in,turn then pull to remove,the lock tabs are part of the valve cover so take care when removing not to harm tabs.

Posted on Nov 14, 2008

Ad

Marc Podeszek

  • 840 Answers

SOURCE: driver window won't work on 2000 mercury mountaineer

So you wanna take a door apart look at the door look for any liitle plastic caps take them out there may be a screws with cover s aound the sides of the trim or little push ins take them out unscrew them/ take the mirror cover off and thentake the bottom of the panel and pull out ward working your way around to the top/ then opull up and out then take and disconnect the wiring/ proceed to take vaprro barrier off looks like plastic take that off and then you can see the whold outside if you are replacing the motor then you will need to look at where the window should be when you need to take ou the bolts and such/ and thats it then go back ward from here/ Please rate my response Thank you very much

Posted on Jan 29, 2009

Ad
chuck943

Chuck Martin

  • 783 Answers

SOURCE: 1997 mercury mountaineer cigarette lighter

http://www.genuineservice.com/genuineservice/en/default?page=genuineService

Go to this website and pick owner guide on left task bar. Input vehicle info then get the owners manual.Your fuse panel info starts on page 120.

To replace lighter just reach around behind it and unhook connectors. The stick something in the socket(I usually use 2 fingers) and twist it counter clockwise. the center will screw out of the sleeve.

Posted on Mar 15, 2009

Anonymous

  • 55 Answers

SOURCE: need to loosen the belt on my mountaineer

1.Remove the air cleaner outlet tube.
2.Use the drive belt tensioner pulley bolt and rotate the drive belt tensioner clockwise.

Posted on May 04, 2009

FUBAR

  • 1168 Answers

SOURCE: 1997 Mercury mountaineer. 143,000 miles.

Hello Sdhesseltine.

The flashing check engine light is telling you the engine is misfiring and your description of the problem confirms that.
There will be a code stored in the vehicles engine computer that will tell you which cylinder(s) is/are misfiring.
Spark plugs, ignition coil, fuel injectors or internal engine problems will cause this.
If it has been a while since your last tune up it would certainly be a very good place to begin.
The usual tune up stuff, spark plugs, air and fuel filters for the basics.
A fuel filter will not be at fault in this case but is part of a tune up on this model.

If you require further advise, please ask me here in comments, be glad to help.
Thank you for using FixYa.

KL

Posted on Feb 01, 2011

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Windows don't go up nor down


All 4 windows? Or just a certain one? Could more than likely a switch issue.

May 21, 2012 | 1997 Mercury Mountaineer

1 Answer

97 Mercury Mountaineer driver side door won't open. Outside handle flops around; inside handle won't open door


Try a slim jim first, down the side of the window. Or AAA or locksmith. If no luck, remove the seat first. Find the screws and bolts around the door handle and arm rest. Most Ford's have screws around the outer side of the panel. I don't believe your's does. The panel lifts or pops off. Once the panel is off, you can reach down and open the door. Just a note. I have done some to where the panel came out in pieces.

Mar 14, 2012 | 1997 Mercury Mountaineer

2 Answers

97 mercury mountaineer power windows


the window regulators may have too much drag. all the windows or just one? after lubing the window regulator and it still drags, the motor for that window will need to be replaced.

Sep 17, 2009 | 1997 Mercury Mountaineer

1 Answer

1997 moutaineer Non functioning power windows, sunroof, door locks and power seats. What's the cause?


Check the fuse under the hood top right corner fuse box Third fuse down on the left side It is a 30 but in older Mercury Mountaineers the wires come slightly corroded and tend to not transfer enough power. So in conclusion either A: the fuse is blown or B: Boost it up to a 50 fuse which is what I had to do

Jun 23, 2009 | 1997 Mercury Mountaineer

1 Answer

Removing 97 mountaineer door panel


just let someone replace it for you , because by the time you do this and that , you won t have a panel left ..............

Jan 21, 2009 | 1997 Mercury Mountaineer

Not finding what you are looking for?
1997 Mercury Mountaineer Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...