Question about Cars & Trucks

1 Answer

My alarm is causing my blinkers,radio and other things not work

Posted by david watson on


1 Answer

Daniel Mc Entee

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An user who is expert in 3 categories / brands.

  • Cars & Trucks Master
  • 1,449 Answers

Check the earth to your alarm .

Posted on Mar 03, 2015


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Blinkers/Flashers do not work on 2003 Ford Taurus.

Im not sure of the right name for it, I call it the blinker sender unit. Is usually under the dash or in some cases under the bonnet, its usually silver and round and has 2 or 3 wires on it

Nov 19, 2012 | Ford Cars & Trucks

1 Answer

Today i woke up and my blinkers stopped working, i thought maybe the fuse was out, no fuse is shorted, but the problem is my 2006 model, I can't find the fuse for the blinkers?? is it under the dash or...

First I would like you to read this article:

Where's The Fuse?

Then, in order to find out what is actually wrong, we would have to know more information.

Are the lights coming on and just not flashing?

Are the lights not coming on at all?

Is the problem affecting both the front and the rear?

Is the problem affecting both the Left and the Right side?

Feb 20, 2011 | Hyundai Elantra Cars & Trucks

1 Answer

1994 toyota camry blinkers flashing wen opening and closing the car doors the blinkers on both sides go off for about one minutes then stops simulating an alarm (the car previosly had an alarm but doesnt...

easiest repair is to remove pigtail connected between ign switcg and alarm dicard and plug factort harness back into ign switch hope this helps please rate

May 07, 2010 | 1994 Toyota Camry

2 Answers

When I turn on my headlights, my radio goes dark and plays static. The domelight and floor lights go on, my dashboard lights don't work, and my tail lights don't work. If the headlights are off, the radio...

It sure sounds like you have a case of "sneak circuits"
These are usually caused by a bad ground somewhere and something is "grounding" through the light bulbs.
Have you changed any wiring or installed a stereo or some other accessory?
You might use a jumper wire and ground the dash and other areas to the negative battery post as a way to find the culprit.

Apr 30, 2010 | 1991 Chevrolet S-10 Blazer

1 Answer

My 94 jeep grand cherokee blinkers and hazards don't work at ALL. the radio comes on when it wants...HELP PLEASE!!

Check for dirty connection at the fuse block ( under the dash) check for loose wire s here too . Possible shaky fuse . (These are cheap)

Have a look at the relay box under teh hood . These things are small cube shaped boxes with econnectors that sometimes go bad. you can mak which one goes where and trade them to see if theres a change. If radio works after a single swap of thes relays then the one you moved is the culprit. Go buy another Note that if something else has gone amiss its that bad relay. The new one may be rotated through the set of connectors until problem is resolved.
first, Check wires leading to the radio. It could be an add-on installation with a flaky fuse holder. its an inline thing that twists apart. turn on ignition and twist this fuse holder to see if it affects things.( listen for on and off whilst monkeying with connector) If so, another can be had dirt cheap at an auto parts store.
You'll cut out the bad one and splice in the new one.
The two things may not have the same root cause. in other words, the hazards switch may be gunked up. Get some tv radio spray cleaner contact cleaner at Radio Shack or an electronics place or hardware store. and clean the switch. There's als o blinker relay unde rthe dash board that may be stuck. These are cheap and easily replaced.

Mar 11, 2010 | 1994 Jeep Grand Cherokee

2 Answers

My blinker on the front on the passenger side is not working and the rear blinker is rapidly blinking, what causes that?

If you replace the front bulbs and it still does it, it means that you have bad blinker wires. the 99 has a TERRIBLE wiring design for the signals so if you can replace the whole thing, you will be better off then replacing bulbs every 5 seconds. I have yet to do it on mine but that is what is causing mine to do the same thing.

Jun 26, 2009 | 1999 Oldsmobile Intrigue

1 Answer

Car alarm stopped working.. Car wont start

the jetta has a faulty alarm system from the factory i have been working on one in my shop. the alarm moddule is inside the dash behind the light switch and has a 10 pin connector and a 6 pin connector. this can be bypassed if you disconnect both connectors and jump the two large wire on the 6 pin connectors, these wires operate your starter. the car will start and run but your alarm will no longer be active. the door locks and everthing else will still work. the only issue i am having is the factory radio isn't working because it is controlled by the alarm. but worse case scenario i can use an aftermarket radio if need be.

Feb 20, 2009 | 1994 Volkswagen Jetta

1 Answer

Elec problems

It seems you have digital problems... check the computer maybe you need to reset him.

Jun 27, 2008 | 1998 Porsche Boxster

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

23424 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides