My low beam lights dont work but high beam donts dont work, high beam do

hi try checking the relays the 1 for the low beam may be faulty

there is a relay under the hood for the lights yes, four pin relay.

High beams dont go on at all? Does the DRL light dissapear when u turn on the headlights? Now, because your high beams dont work, it more likely means that you need to replace your bulbs. Because if it would be a problem in the car itself, only the DRL system would fail. Im 80% sure that changing your bulbs will solve the problem.

if low beams and high beams dont work check the fuse.if only the low beam lights dont work.and bulbs good.i am looking at dimmer switch.

If your low beams don't work you may have to change your high beam- low beam switch. Take your vehicle to any autozone or similar auto parts store who will scan your computer which will give you all or part of the answer on how to proceed.

If they work at night leave it alone
(Those ******* "Driving Lights" cost you gasoline to run.)

Could be that your high beam light's are burnt out and need to be replaced. When you say the the switch is new you mean the lever on the stearing collum is new right?? Good luck

thare is a high beam relay and a low beam relay in the fuse box find the low beam relay and replace it. if this dont work its probabley the switch

There are no relays for the headlights. Your problem could be from the headlight switch. You would have to check and see if you have power coming out of the switch on the low beam side. Check with a test light.

The headlamp circuit is rather simple. From the 15 amp RH headlamp fuse, there is a red w/yellow trace that goes to the RH high beam. Out of the 15 amp LH headlamp fuse, the wire going to the LH Hi beam is solid red. Both of these wires should have power when the headlamp relay is energized. The wires from the Hi Beam bulbs going back to the switch should both be red w/black trace. The wire going from the headlamp relay to power the 2 15 amp fuses is white. The headlamp switch applies a ground to illuminate either the Lo Beams or the Hi Beams.