2005 Chevrolet TrailBlazer LS Logo
A
Anonymous Posted on Mar 02, 2015

2005 trailblazer when we lift the middle row seat it leaks oil . how to fix it ?

When we lift up the middle row seating , there oil leaking into a spot. We clean the bar and next time we lift it up oil there again

1 Answer

Mike Ceslow

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

  • Chevrolet Expert 206 Answers
  • Posted on Mar 02, 2015
Mike Ceslow
Chevrolet Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Joined: Aug 31, 2012
Answers
206
Questions
2
Helped
59437
Points
644

Replace seal

If you need further help, I’m available over the phone at https://www.6ya.com/expert/mike_9693b5ad75773352

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

I have a 2005 Chevy Tahoe the second row middle seat belt won't retract how can I fix this

you cannot fix these belts you have to change it go on youtube look on there for your answer
0helpful
1answer

I have 2 bucket seats in the middle of my 2007 montana. can i take one out?

Yes of course you can remove the seat. There is a pull at the rear of the seat in the middle (down on the frame) The pull is a loop of material. You need to pull that up with solid force, this will release the lock so you can tilt your seat forwards. Once the seat is rotated forward enough, you will be able to lift the seat out.
I leave my seat out behind the drivers seat most of the time for easy access into the back and just putting stuff in the car. Also, the side clearance height is higher than the rear hatch height.
0helpful
1answer

The window for the third row seat is leaking water, How do i fix it?

sounds like the seal around the window has gone bad and it can be replaced and they also make a sealant to place around some windows by i woiuld suggest replacing seal around window....hope this helps and good luck
0helpful
1answer

Why is there no power to third row seat?

Power 3RD Row Seat Problems and Tranny Shutter - Ford Truck ...

www.ford-trucks.com > ... > Expedition & Navigator
Mar 27, 2014 - Expedition & Navigator 1997 - 2002 and 2003 - 2006 Ford Expedition andLincoln Navigator SPONSORED BY: ... First the 3RD row seats won't fold down, noclicking, no sounds, nothing. I the fuses are good and there is power at the fuse box, but no power at the motors or switches. Based on continuity ...

3rd row powerfold seat stuck down - Ford Truck Enthusiasts Forums

www.ford-trucks.com > ... > 2007 - 2014 Expedition & Navigator
Mar 14, 2010 - 3rd row powerfold seat stuck down 2007 - 2014 Expedition ... 2010, 2011, 2012, 2013 and 2014 Ford Expedition and Lincoln Navigator ... I also tried lifting the seat while my wife was pushing the button to raise it, to no effect. There is defnitelypower going to the motor but it just isn't ... Join Date: Feb 2005.

No power to third row seat on 2005 lincoln navigator - Fixya

www.fixya.com/cars/t12295627-no_power_third_row_seat_2005_lincoln
Apr 4, 2012 - no power to third row seat on 2005 lincoln navigator third row seat is ... U will have to replace the entire power seat transmission, there is no ...

Lincoln Navigator Review - Edmunds.com



0helpful
1answer

Tried to lift the roof on convertable XK8 and hydraulic oil started to leak from the ceiling arounf the light cluster. How do I get at it to fix the leak/problem

you have a hydraulic leak there are two lines that meet in the middle by the light cluster both lines should be changed you have to pull back headliner to see lines and leak one line runs under drivers side panel near side of seat and other line runs under passenger side panel near the side of the seat going to the back seats and to the trunk where hydraulic motor and fluid box is its a hard job and takes about six hours to do lines arer 214.00 fluid is 70.00 and about 800 in labor
1helpful
1answer

I have a old mercury villager ...i want to replace the middle row seat with last row seat ...is it posible...?

The middle row seat slides forward to the middle position (and several other positions as well.)

Owners manual explains how to slide rear seat foreard.
Remove middle row seats. Lift handle under 3rd row seat cushion on passenger side. Raise seat cushion up until it locks up. Then lift the lever on the passenger side of seat and pull seat forward until it locks in place.

if you don't have owner manual, go to motorcraft.com, pro center, tech info, owner manual.
join our group for free help.

please rate too. Thanks.

http://groups.yahoo.com/group/villagerquest/
0helpful
1answer

Middle row back seats...how can I remove or collapse them, I know back seats fold completely to floor, but what about middle row?

first fold them flat then pull the handle which will release the rear bottom brackets and allow you to pull back and lift the entire seat out of the van....both seats.
9helpful
2answers

I want to make my 1999 Mercury Villager Sport into a cargo loader, with just the front seats kept and the rest of the back empty. How do I remove the other 3 seats? So far, I can't get any of them to budge...

the middle seats come out easily. There are 2 handles you have to lift up on each of the bucket seats, they are in the front of the seat down by the seat tracks. After you lift them, tilt the seat upward in the front and rotate them backward. Then lift out of the hooks. Each seat is held down by 4 hoks.

The 3rd row seat is not designed to come out xcept by a technician. It does slide forward all the way up to the front seat. It has a sliding seat track.
First, lift the T handle under the seat cushion on the left front side of the seat. This will allow you to lift the seat bottom up all the way to lcok in the full up position.
Then, lift the lever on the same side of the seat and slide the seat forward. It will stop in 4 places.
Rear -Rear
6 inches forward of that.
another two ft to the second row seating position
full frward against the front seats.

Pleae rate as fixya if this helps.

c4253aa.gif Seat —Third Row Bench Removal
sxv~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Removal of the third row bench seat requires more than one technician.
  1. Remove the second row seats. For additional information, refer to Seat—Second Row .
  1. Remove the floor mats.
  1. Lock the seat cushion in the upright position.
    1. Lift the handle to release the cushion.
    1. Lock the seat cushion in the upright position.
0235766.gif
  1. Move the third row bench seat to the second row position.
    • Lift the seat track release handle.
  1. Remove the two bolt covers.
  1. Remove the two seat track front bolts.
  1. Remove the four seat track rear bolts.
    1. Position the rear seat cushion floor cover aside.
    1. Remove the four seat track rear bolts.
  1. Remove the third row bench seat.
Not finding what you are looking for?

140 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...