- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The window indexing feature is used to lower the driver and passenger power windows approximately 4 mm when the door is opened. This is necessary to allow the top edge of the window to clear the window weather-strip. This feature will also raise the window to the fully seated position once the door is closed.
Is just the driver door not working ?
Observe the operation of the driver window and front passenger window while opening and closing their respective doors. The windows should index DOWN and UP when the doors are opened and closed.
? If either window does not index UP or DOWN, refer to Window Index Feature Malfunction.
Window Index Feature Malfunction
Ignition ON, observe the scan tool Driver Door Ajar Sw and Door Ajar Switch parameters while opening and closing the driver and passenger doors, the parameter should change from Door Closed to Door Ajar.
? If the parameter does not change when opening and closing the doors, refer to Door Ajar Indicator Malfunction .
Ignition OFF, disconnect the harness connector at the appropriate window motor.
Ignition ON, with the door closed, test for greater than 10 volts between the signal circuit terminal 5 and ground.
? If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
With the door open, test for less than 1 volt between the signal circuit terminal 5 and ground.
? If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
If all circuits test normal, replace the window motor.
Your best bet mite be to take your vehicle to a qualified repair shop (GM dealer )
repairpal.com > Problems > Hyundai > Elantra Hyundai Elantra power windows goes down , but does not want to go up. ... Now I can only open it using the drivers side control and close it using only the passenger side control. ... Just the rear passenger window doesn't work. ... All of the windows in the car except the front driver side window had stopped working.
Mar 7, 2011 - Uploaded by Nthefastlane
Click here: https://rdy.cr/f7a3a1 How to fix slow power windowsthat get ... technician finds the true problem. that doesn't mean every mechanic is a ... Like it shifts towards the front of the car and leaves a 1/2 inch open .... I have an 09 Toyota Rav4 and had a little shutter on the last 1/4 of the window closing.
could be either, either way you are going to have to get in the door so remove the panel , the window track should have slots so loosen them and bit lubricate the regulator slides and try it if the window moves freely thenits not the motor, good luck
visit youtube and type in audi a6 window repair, it has a great video there that will save u over 500 dollars, believe me i did it myself and im in a wheelchair.
take the door panel off and have a look ,sounds like where the glass is attached to the lifting mount and the rubber that hold it in has come loose allowing window to go sideways
Stephen,
I used to have the same problem wiv my 1994 3 Series Electric window and what I done was used the back of a plastic knife and cleaned out the seals (put the knife in the bottomom and took out a load of moss that had built up) Hope this helps
It is likely the window motor is wearing out and will need to be replaced. You can always try a different switch on those wires to rule out switch problem. Otherwise, the motor will have to be replaced.
×