SOURCE: Help changing thermostat 2002 chevy venture
THERMOSTAT REPLACEMENT
Removal Procedure
1.Remove the air cleaner and duct assembly.
2.Drain the coolant until the coolant level is below the thermostat. Refer to Draining and Filling Cooling System .
3.Remove the crossover exhaust pipe.
4.Remove the radiator hose from the thermostat housing
5.Remove the thermostat housing bolts and clean any sealer from the bolt threads.
6.Remove the thermostat housing and gasket.
7.Remove the thermostat.
8.Clean the mating surfaces.
Installation Procedure
1.Install the thermostat.
2.Install the thermostat housing and gasket.
3.Install RTV sealer, GM P/N 1052366 or the equivalent, to the thermostat housing bolt threads. .
4.Install he thermostat housing bolts.
Tighten
Tighten the bolts to 25 N.m (18 lb ft).
5.Install the radiator hose to the thermostat housing.
6.Install the crossover exhaust pipe
7.Install the air cleaner and duct assembly.
8.Fill the cooling system. Refer to Draining and Filling Cooling System .
9.Inspect the cooling system for leaks. Repair as necessary.
http://www.2carpros.com/forum/automotive_pictures/99387_Graphic2_59.jpg
http://www.2carpros.com/forum/automotive_pictures/99387_Graphic3_26.jpg
http://www.2carpros.com/forum/automotive_pictures/99387_Graphic4_13.jpg
SOURCE: 2000 Chevy Venture shows gas gauge as always full..
if the remote works but the switches inside the van doesn't then the most likely fix would be the switch, tthough it is strange that both would quit. the place too start would be pop out the switch with a small screwdriver and disconnect the connector. the top left pin and the top middle pin is the unlock circuit in the switch. check continuity with your multimeter while pressing unlock. if no continuity, then get a small piece of wire and jump those pins in the connector,( the top right and center ) you should hear the doors unlock, then you know for a fact that the switch is bad. the unlock is used more than the lock so it is a more common failure. you can also use a continuity test on the rear wiper switch. though it is more common that the motor would stick from not being used. hope this helps if you have any more questions i am glad to help... dustang
SOURCE: 2002 Chevy Venture fuel filter
Under vehicle, driver side, below seating area, front of fuel tank, mounted on frame rail in fuel line, just follow the line from the tank.
SOURCE: fault code p0440 CHevy venture
I had that exact code a couple weeks ago. Mine needed new oxygen sensors. They(there are 2, only one was throwing a code, but I had both replaced) cost a little over $100 to have replaced.
SOURCE: replacing a 2002 Chevy Venture front wiper motor
Look online for the wiper module for this model. This is a common issue to include operation without the switch being activated. Everything is controlled by the module which screws directly on the front of the wiper motor by 3 torx head screws and measures about 4" x 4" and is very easy to install. The motor should be on the firewall. The modules run anywhere between $35 and 65. Let me know if you need anything else.
398 views
Usually answered in minutes!
×