Dealer charges for oil pan gasket replacement
SOURCE: 2000 Chevy Blazer
i am working on a s 10 of the same yaer and problem i will post my results after tomorrow when i have finished the job i bout this truck cause of the forum i own one that is a great one and this one is for experimental purpose i will let u know so far you cant lift the motor with a jack or a hoist so we r going another route in the mornin
Gasket = $35 (permatex rubber)
Labor - my manual says 3 hours.
You'll have to be responsible for figuring out the labor price per hour depending on where you are located.
In MI, a garage is about $50/hr, and dealership = $85/hr
CA might be $95/$150/hr.
Parts are minimal on the job - its all labor.
Figure in about $20 for shop supplies... gasket remover, sealant, rags, etc.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: replac 2003 monte carlo oil pan gasket
To remove the oil pan on any vehicle, first remove anything obviously in your way...starter, exhaust pipe etc. Then disconnect the engine mounts and raise engine to gain sufficient clearance between frame and pan. You cannot support the engine from under the pan so either use a fixture above the engine or put blocks between mounts and engine to support it. After all rail bolts have been removed, remember that the oil pump pickup will interfere with removal somewhat but pan can be maneuvered around it. Anything preventing you from getting the pan out will then need to be removed or moved as they are identified. Be careful when raising the engine that you do not break anything above it as it comes up.
SOURCE: My Chevy 2002 Tahoe is leaking oil. They told me
this truck is equipped with an aluminum oil pan you could have 1 or several things going on... a stripped drain plug which is causing it to leak or it may be a leaking front seal or a rear main seal. If it is a front seal it is not to labor intensive. But if it is a rear main seal leaking it will require the transmission to be removed since the seal is a 1 piece rear main
SOURCE: OIL PAN GASKET LEAK
The engine has to be supported and the cradle under the engine has to be removed. After everything is reinstalled the front end has to be realigned.
Testimonial: "Thanks for your help, but i think i need a little more info. before tring this."
98 views
Usually answered in minutes!
×