2004 BMW 5 Series Logo

Related Topics:

D
Dannie McKIM Posted on Feb 19, 2015
Be the first to answer

When fitting new springs to my bmw e60 530i 2004 how do I remove the rear seats or do I have to remove them?

Answer This Question

5 Related Answers

Anonymous

  • 837 Answers
  • Posted on Mar 23, 2009

SOURCE: How do you remove the rear seat back on a BMW 318d

6353dd9.jpg

Diagram above

Ad

Anonymous

  • 67 Answers
  • Posted on Jan 10, 2011

SOURCE: how do access the battery on a 1994 bmw 530i?

Remove the two plastic covers around the seat belts then pull straight up on the front of the seat (it may take a sharp tug)

Anonymous

  • 34 Answers
  • Posted on Feb 07, 2011

SOURCE: remove rear seat 1994 525i

If you are looking to just remove the rear seat bottom all you have to do is pull up on the front edge

alicantecoli

Colin Stickland

  • 22516 Answers
  • Posted on May 29, 2011

SOURCE: 2004 series 3 BMW 316i

you shouldnt need to remove the rear valance to fit a towbar ,i would suggest you contact a authorised towbar fitting workshop as it is not permitted to fit a towbar yourself ,it has to be done by a company with the correct authorised dealership as the towbar has to be certified with a europeon certificate of homoglonation and a plaque .then vehicle has to be presented at the vehicle inspection station for conformity .Then the paperwork of the vehicle changed to show its fitted with a towing hitch and a fee paid for this service .alicantecoli_18.jpgalso the electrics have to be connected by a auto electrician as every annual vehicle inspection the electrics are tested as well where a towbar is fitted .

Testimonial: "THANKS FOR INFO DID'NT KNOW IT WAS THAT INVOLVED. WILL SEE HOW MUCH GARAGE CHARGE."

Bill Boyd

  • 53816 Answers
  • Posted on Dec 25, 2014

SOURCE: Remove rear door handle from a 2004 525i bmw

remove the door lining and you will see nuts up on the handle on the inside

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do I remove the lower rear seat
Hi there on a 3 series there are two heavy duty clips that hold the seat down and they are located along the front edge of the seat right in the centre of where the left and right rear passengers would sit, on these two locations grab under the seat and pull upwards fairly hard and the front of the seat will pop up, once the front is up then scoop the seat out. hope this helps
Read full answer
Feb 27, 2015 • 2004 BMW 3 Series
0helpful
1answer

How do i replace the fuel pump in my 2004 525i BMW

I believe you gain access to it by removing the rear seat then a cover plate in the flooring. Hope this helps.
Read full answer
Nov 30, 2014 • 2004 BMW 525i Touring
0helpful
1answer

Who do I remove rear seat for a BMW 760li?
Most rear seats need to be unlatched from the very bottom on each side. Try sliding the driver and passenger seats fully forward. With your back against the front seat press forward toward the trunk on the bottom of the rear seat on one corner at a time near the floor and lift up. This should release the latch. To replace the seat simply slide the seat back into place with the front slightly raised upward and push the seat in toward the trunk then push down til you hear the latch catch.
Read full answer
Nov 15, 2014 • 2004 BMW 760Li
0helpful
1answer

I have just fitted two new real coil springs to my Ford escort mk4 cabriolet but now the rear left is sitting nearly an inch higher than the rear right what could be causing this ??? thanks .
The coils of the springs have to be positioned so that the end of the coil is in a depression in the seat . check that the spring that is sitting high is fitted the right way up and that the end is in the seat correctly. Normally coil springs have one end ground off so that it is flat while the other end just has the steel cut off. This is the end that has to be positioned correctly. Make sure that the rubber cushion pad is fitted correctly for the flat end.
Read full answer
Jun 08, 2014 • Cars & Trucks
1helpful
1answer

Remove rear seat
To remove the bottom, just pull upward on the seat in the middle. Do you have the fold down rear seat or the fixed one. The fixed one has bolts near the top on the sides and at the lower edge slightly inward on both sides
Read full answer
Apr 14, 2014 • 2004 BMW 320i
0helpful
1answer

How do you take the back seats out of a bmw 320i se to fit seat covers
To remove the rear seats, force your hands under the front of the seat bottoms and lift with a quick, short tug. The bottom cushion lifts out with no tools. There will be a couple of bolts holding the seat backs in place.
Read full answer
Oct 06, 2009 • 2004 BMW 3 Series
2helpful
1answer

Are there any special tools needed to change brakes and rotors on a 2004 bmw x3
Front or rear. Front just sockets and mabey Allan wrench set. Back set, a spring removal tool and sockets. Metric
Read full answer
Sep 11, 2009 • 2004 BMW 3 Series
1helpful
1answer

FUEL PUMP
Hello!

The fuel pump on a 3 series BMW is located under the rear seat.
To access it you will need to remove the lower part of the rear seat by pulling it up.
Then an oval shaped cover on the passengers side should become visible.
Under this cover is the fuel pump.
I would suggest taking the cover off and inspecting for signs of replaced parts.
(new parts should be shiny ;)

Hope this helps!
Read full answer
Sep 28, 2008 • 1999 BMW 328 Series
0helpful
1answer

Replacing boot struts
Hi GB52. Just done this myself, should take 15 minutes perside max. 1/ remove rear seat cushion by bumping the centre back and up, lower the back rests down. 2/ Unscrew the striker plate from the seat side bolster and the bolt at the lower edge of the bolster Removing the bolster takes a bit of fiddling. 3/ use a flat-head screwdriver to release the strut spring clips - use the new ones as a guide. 4/ remove the old strut and fit the new one. reinstall the bolster, bolt and strike plate. note; when replacing the rear seat cushion, ensure the seat belts are fed through first and check that the seat retaining clips properly engage the floor panel brackets.

Hope this helps,

Davo
Read full answer
Jul 31, 2008 • 1983 Ford Fairmont
0helpful
1answer

FIT SEAT BELT
TO GET AT REPEATER LAMP ON O/S MIRROR ON A GOLF TDI SE 2004 REMOVE THE TOP COWLING AND THE GLASS NEXT TWO SCREWS AT THE BOTTOM TO REMOVE THE LAMP NO BULB BUT FIT NEW LAMP
Read full answer
Jun 20, 2008 • 2004 Volkswagen Golf
Not finding what you are looking for?

View Most Popular

2004 5 Series

  • Cars & Trucks

Related Question

How do I remove the lower rear seat

  • 2004 BMW 3 Series

137 views

Ask a Question

Usually answered in minutes!

Popular Questions

BMW X5 Trans Fail Safe Program,

BMW X5 Series Cars & Trucks

2007 BMW X5 Fuse Box Locations & Fuse Diagrams ?

2007 BMW X5 3.0si SAV

BMW X5 LIFT GATE RESET BUTTON

BMW X5 Series Cars & Trucks

Radio has no sound

2001 BMW 5 Series

BMW X5- power wheel, power seats

2002 BMW 5 Series

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top BMW Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

old marine
old marine

Level 3 Expert

2426 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
. 2004 5 Series Manual

2004 5 Series

Loading...