Nneed a diagram of serpintine belt e46 320d 2002 model

Found this in my database. I had to go to paint and draw it.

there is a hole in the tensioner that you can put a ratchet in and take the tension off of the belt ,You can than easily replace the belt

What engine?

is it the one belt or does it have the 3 belts

When did GM stop putting a sticker under the hood with the accessory belt layout? I prefer Mopars,but I did like this idea.If changing a belt on my vehicles,I clean a spot of the radiator support,draw a diagram,and spray some clear paint over it.If you have to go through the trouble of finding a diagram,do this on your truck.

http://www.focusfanatics.com/forum/showthread.php?t=43557

there you go, if you need another diagram for one without AC its in that same page, remember to use belt dressing, go slowly, and if you need one, use a belt tensioner wrench to help you slide it off, a special trick is to put the belt on the water pump pulley last, as the rounded edge is easier to slide on to, as well as making sure the belt length is correct

This is a drive belt routing for a Toyota Camry 2002 with a 2.4L four-cylinder engine. I hope this will help you out.

2002 FORD TRUCK WINDSTAR 3.8L SFI 6CYL REPAIR GUIDE

Drive Belt Routings



Fig. Accessory drive belt routing-3.0L engine




Fig. Accessory serpentine belt routing-3.0L engine




Fig. Accessory serpentine belt routing-3.8L engine


I hope help you with this. Good luck.

Go to autozone.com. They have free repair manuals online with diagrams.

for the most part there is a diagram under the hood showing you how the belt goes on try this website to see if they have you car listed its www.autozone.com and you can also check at the auto parts store where you are going to get the new belts to see if they have a diagram for your car