At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Reset oil change light. some GM cars and trucks switch on ignition, do not start engine press gas peddle to the floor then release and switch ignition off. This procedure is in the owners manual.
turn off the car put the key on on,press the gas pedal two times then the third time hold down until the light starts flashing.then turn it to offthe key and start it.It should go out.
Turn your key to the on position, now press the gas peddle down three times
with in 7 seconds. You may have to do this more than once. After
setting turn key off and then start engine, light should go of after a
few seconds, if not repeat procedure.
Information taken from: http://www.idavette.net/tech/oilreset.htm
[quote] The "Change
Oil" indicator is reset by using a sequence of Driver Information Center
(DIC) key presses as follows:
1. Turn ignition "ON", but do not start engine. (ALDL pin
"G" should NOT be grounded.)
2. Press the "ENG/MET" button and release, then, within 5 seconds,
press it again.
3. Within 5 seconds of Step 2, press and hold the "GAUGES" button.
While the button is held, the "Change Oil" indicator will flash.
4. Continue holding the "GAUGES" button until the "Change
Oil" indicator stops flashing and goes out, indicating successful
completion of the reset cycle. This should take about 10 seconds.
If it does not successfully reset, turn ignition "OFF" and repeat
the procedure from Step 1.
[/quote]
Turn the key to the on position and press the gas peddle to the floor 3 times within 5 seconds then wait 10seconds this will reset the oil service light .P.S THIS ALL HAS TO BE DONE WITHIN FIVE SECONDS OF TURNING ON THE KEY AND HAVE THE DOORS SHUT :) THEN START THE VAN
Try this. With the key on and the engine not running push the gas peddle to the floor and release it three times then hold it to the floor until the oil light flashes. This should reset the oil indicator light. It should not take more than about 20 or 30 seconds.Good luck.
×