Cars & Trucks Logo

Related Topics:

eric sanes Posted on Jan 23, 2015
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

The rear lights and signal lights stop wrkng in my bros car,the windows dsnt go up nor down,and he have to reprogram the radio every time he gets in the car,fuses r ok and relay as well,what can be happening?????

1 Answer

Joseph Prosser

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Master 780 Answers
  • Posted on Jan 23, 2015
 Joseph Prosser
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Apr 15, 2010
Answers
780
Questions
0
Helped
411031
Points
2711

First thing is to measure voltage across battery (should be 12.6volts). If less than 12v then battery may be in poor condition and most things will not work properly. Before renewing the battery when the engine is running again check voltage across battery. It should read 14.4volts; this is the recharge voltage supplied by the alternator. If the voltage is less than 14v or the voltage supplied is intermittent then change the carbon brushes and perhaps the voltage regulator on the alternator (less than £10 on line)

5 Related Answers

tooahnippah2

  • 1 Answer
  • Posted on Dec 01, 2008

SOURCE: 1998 monte carlo brake lights

I have the same problem,it's the switch inside the turn signal assembly.Unfortunately the entire assembly switch and all has to be replaced.
Hope this helps.

Ad

Hayward Cowan

  • 59 Answers
  • Posted on Jan 20, 2009

SOURCE: 1999 f150 turn signals and brake lights out. High mast still work

The signal lights work through a relay but the brake lights work through the signal switch, if both are out I think you'll find the problem is the signal switch.

Nicholas Csorba Jr.

  • 148 Answers
  • Posted on Feb 17, 2009

SOURCE: Tail lights don't work on 1998 Chevy Silverado.

check the wiring from the tailights back to the fuse panel, it sounds like an open connection. if i recall correctly check under the dash on the drivers side near the fuse panel for a bunch of wires in a bundle and look carefully for a wire or two that are cut/shorted/or seperated, you can also check under the drivers side kick panel by the hood release.

Ashley Robertson

  • 36 Answers
  • Posted on Jul 21, 2009

SOURCE: Toyota 4runner gate window, wiper, and keyless entry not working

make sure the back window is all the way up then try the wiper, if it still does not work then it is a sensor for the rear window (about $30.00) if you installed it yourself

I’m happy to help further over the phone at https://www.6ya.com/expert/john_5260ce46f2f674cc

Anonymous

  • 79 Answers
  • Posted on Feb 05, 2010

SOURCE: Rear lights, brake lights and turn signals do not

I would check if they also run off of a relay, You could have a wire that is either broke or it is grounding out somewhere.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My car dsnt want to start i have replaced the ignition housing they broke it trying to steal the car it shows the orange key on the dash board they tried reprogramming it still nothing its polo 2006 m

This unfortunately is going to be an electrical diagnosis nightmare. And unless you have access to the right diagnostic equipment and the means to reprogram you will likely be farther ahead to save yourself the time and frustration and take it into a repair facility.
0helpful
1answer

2007 mazda 6 front and rear driver and rear passenger windows not working.

The windows need to be re-learned.
- Park the car on level floor. Shift the gear lever to P or N. Pull up the hand brake. Start the engine.
- Sit on driver's seat. Lower the driver side window. Keep the button pressed for three to four Seconds after the window glass sits completely.
- Move up the window glass and do the same as above.
- Do the same with passenger side window glass while sitting on the passenger seat.
- Repeat the same procedure for rear windows one by one from their own buttons.
- Sit on a drivers seat and operate all the windows one by one.
Note:
If the problem persists, pull up the body diagnostic error codes with Diagnostic computer or re-learn the windows with the same machine.
2helpful
1answer

Fuses panel described in English

Hope this helps your out. I know the diagram and locator is a bit blurry but hopefully it gets what you need.
Drivers kick panel:
Front wiper 20A - Front wiper system Cigar 15A- Cigarette lighter Audio 10A- Audio, remote control mirror Air Bag 10A -Air bag diagnostics Stop lights- 15A -Rear brake light, high mounted stop light ECU B+ 10A - Shift lock actuator, transaxle controle module, radio, engine control module Room 10A - Interior light, clock, ignition key reminder, rear cargo area light switch ABS 10A- Anti lock brake system control unit ECU IG1 10A - Transaxle control module, shift lock actuator, ABS control unit, DRL unit Meter 10A - Instrument panel, back-up switch, electronics time control module, inhibit switch Turn signal 10A- Hazard switch ,front and rear turn lights, turn indicator IGN1 20A - Ignition switch ABS 30A- ABS pump motor TNS 30A- Tail light, license plate light COOL/FAN 30A- Cooling fan Cond/Fan 20A- A/C condenser fan Starter 15A- Start signal , Fuel pump Blower 25A- Blower Motor SR/ACC 10A - Ignition switch Hazard 15A - Hazard and turn signal light D/Lock 25A- Door locks ABS 30A - Anti lock brake system control P/W RH 20A- Power window motor right hand P/W LH 20A- Power window motor left hand IGN2 25A- Ignition Switch
Engine compartment :
Head 25A- headlights IG 2 30A- Ignition switch IG coil 15A -Ignition coil, condenser,generator IC regulator, diagnostic connector. O2 down 10A- Rear O2 sensor O2 up 10A- Front O2 sensor Fuel pump 10A -Fuel pump unit Injector 10A -Fuel injector ,camshaft positioning sensor, purge solenoid valve, EVAP, IAC actuator, Mass Airflow sensor, EGR stepper motor. fuel pump relay coil, vehicle speed sensor. A/Con 10A - A/C compressor controls, cooling fan BTN 30A- Brake light , high mounted stop light. Tail light LH 10A- License plate light, tail light , rear combo light, instrument panel illumination Tail light RH 10A-License plate light, tail light , rear combo light, instrument panel illumination Head low 15A- Headlight Head Hi 15A-Headlight Horn 15A- Horn jlmacman.png jlmacman_0.png

Inside kick panel jlmacman_1.png
0helpful
1answer

Interior lights and radio won't work

Check your fuses. More than likely blew one of them.
0helpful
1answer

About the radio signal

I have a quite simular problem !
What`s realy strange is that when the lights are off, it`s seams ok, but when i turn on the lights (park lights ore full with xenon) the signal strenght is much worse ?

Anyone heard abot this problem ?

By the way, i live in Norway.
10helpful
3answers

Just bought second hand 98 chevy lumina and someone stopped me saying I have no brake lights, so I checked and I only see a place for backup lights and turn signal lights. Why do I not have any break...

The brake light in the rear window and the main brake lights are on a different circuit. After the signal leaves the activating switch on the brake pedal arm, it splits. One circuit goes straight to the high mount brake light, the other goes into the turn signal switch. If the rear turn signals work but the brake lights don't, suspect the turn signal switch, not the bulbs and wires. Better to check this before removing and checking bulbs, wires and fuses. It is a common problem with the W-body cars like Lumina, Monte Carlo, Buick Regal, Olds Cutlass and Pontiac Grand Prix. (Approx 94-99 models). Part number is GM 190005031 (w/o radio accessory control) or 19005032 (with radio controls)
0helpful
1answer

1989 Mercury Tracer Sta. Wgn.

your owner manaul has it. your fuse cover should have chart too.

here is 96 tracer. You also have main fuses under hood.

INTERIOR FUSE JUNCTION PANEL REFERENCE CHART Fuse Fuse Rating Color Protected Components (REAR WIPER) 10A Red Rear wiper and washer motors, heater and A/C relays, daytime running lamps control (Canada), climate control assembly panel illumination HAZARD 15A Blue Front and rear turn signal lamps, turn signal indicator lamp, indicator flasher ROOM 10A (1.9L)
15A (1.8L) Red
Blue Dome and map lamps, safety belt warning chime, ignition key illumination, luggage compartment lamp, vanity mirror lamp, radio chassis (memory), power door lock relay, shift interlock system, powertrain control module (PCM), radio amplifier (memory) ENGINE 15A Blue Fan control (FC) relays, PCM relay RADIO 15A Blue Radio chassis, radio amplifier, remote control mirror, instrument panel illumination (DOOR LOCK) 30A Light Green Power door lock actuators BELT 30A Light Green Passive restraint control module, passive restraint motors (POWER WINDOW) 30A Light Green Window regulator electric drives METER 15A Blue Instrument cluster, backup lamps, rear lamps, speed control system, shift interlock system, safety belt warning chime, passive restraint control module, hazard flasher, PCM (1.8L Canada) WIPER 20A Yellow Windshield wiper motor and windshield washer pump STOP 20A Yellow Stoplamp, horn (1.9L only), rear hi-mount lamp TAIL 15A Blue Parking lamps, cornering lamps, rear lamps, license lamps, compartment lamp, instrument panel illumination (SUN ROOF) 15A Blue Sliding roof panel motor ABS 10A Red Anti-lock brake system (ABS) (1.8L only) (DEFOG) 20A Yellow Rear window defroster HEATER 30A
circuit breaker — A/C blower motor HO2S
(ON INTERIOR FUSE JUNCTION PANEL SIDE) 10A (1.9L)
20A (1.8L) Red
Yellow Heated oxygen sensor (HO2S) CIGAR
(ON INTERIOR FUSE JUNCTION PANEL SIDE) 20A Yellow Cigar lighter knob and element CIGAR 20A Yellow Cigar lighter OBD II 10A Red Data link connector #2 BLOWER 30A Light Green Blower motor relay HORN 20A Yellow Horn (1.8L only)
0helpful
2answers

Back windows are not rolling down

Rear windows on my 2002 Taurus stopped working. Fuse OK. Problem is only with the rear windows. Started as an intermittent problem on one window and now neither rear window works.
Not finding what you are looking for?

52 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...