Question about 1997 Lexus ES 300
If not labeled in you manual then I would look for the fuse that is for the trailer harness. You may not have a hitch but I would bet you still have the harness.
Posted on Jan 19, 2015
SOURCE: burned out license plate bulb
remove felt liner from rear of trunk, (liner directly behind rear lights in side trunk) should be 4 plastic Phillips head screws. Loosing screws, then slowly peel liner away. You will see 3 nuts on each side, removing these nuts will loosing the rear light lenses, so you can pull the lense away from the body from the out side to gain access to the license plate bulbs. Re-install in reverse order. While in there I would recommend replacing your brake light and reverse light bulb. Hey your already in there might as well do a little preventive maintance.
Posted on Jan 31, 2009
SOURCE: License plate light not working.
check your light fitting units the normally corrode also the wires some times snap on the of side rear inner-wing normally due to a slight bump they break the wires check wires from both side and if one side dosn,t have power just run feeds from that to your non working lights but becarefull for any shorting from the wires when you connect you new wiring
Posted on Oct 20, 2009
The lic plate light are on the same fuse as the park lights so if they work the fuse is good, try removing the bulb assembly and look for things like a bad ground caused by dirt or rust, if you have a 12 volt test light you can check to see if you are getting any power to the light socket or the wires leading up to the sockets and you can trace back to where the problem is.
Posted on Sep 09, 2012
Tips for a great answer:
Aug 21, 2016 | Ford Cars & Trucks
Jan 24, 2016 | Cars & Trucks
Dec 10, 2015 | Ford Cars & Trucks
Nov 16, 2015 | Chevrolet Cars & Trucks
Jul 09, 2013 | Cars & Trucks
Apr 12, 2012 | 2007 Audi A4 Convertible
Oct 23, 2011 | Cars & Trucks
Aug 19, 2011 | Ford Expedition Cars & Trucks
Dec 09, 2010 | 2000 Toyota Avalon
90 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: