Have a Alpine Symphony Hi-line unit is a YIE100011PUY, am looking for a wiring diagram to show the 2 x 12 pin wiring colour codes of the wires.

Question edited for clarity.
Question moved to model category.

https://www.google.com/search?q=metra+wiring+harness+diagram

and

2016 1500 radio wiring diagram

DODGE RAM FORUM https://www.ramforum.com > ... > Audio & Electronics
Oct 7, 2017 - Hi, After being convinced to put in an amp, I need some help wiring my Audio control Lc6i. I have the base system, not the Alpine .

2016 non alpine speaker wiring schematic
Jul 12, 2018
2016 RAM 1500 Wiring Diagram
Feb 2, 2023
More results from www.ramforum.com

Dodge Ram Radio Wiring Diagram

Pinterest https://www.pinterest.com > Explore > Vehicles

Mar 19, 2022 - Dodge Ram Radio Wiring Diagram ' Diagram, Dodge ram, Dodge dakota.

Dodge (2014-2016), Jeep, VP4 NA 52-pin Head Unit ...

PinoutGuide.com https://pinoutguide.com > Car-Stereo-Chrysler-Fiat

Dec 13, 2021 - OEM radio stereo wiring. Hardware connector pinouts and cables circuits ... Dodge Ram Truck 1500 (2013 - 2016), Ram Truck 2500 (2013 - 2016) ...

..

Edited the first part for clarity.

Hyundai Santa Fe SE 2009 - SYSTEM WIRING DIAGRAMS

https://portal-diagnostov.com > 2020/03/26 > radio-hyu...

Mar 26, 2020 - RADIO - Hyundai Santa Fe SE 2009 - SYSTEM WIRING DIAGRAMS Radio Wiring Diagram, with Amplifier & Rear Seat Entertainment (1 of 2).

• 
  

  All Wiring Diagrams for Hyundai Santa Fe Limited 2009

  https://portal-diagnostov.com > 2020/07/22 > all-wiring...
  
  Jul 22, 2020 - All Wiring Diagrams for Hyundai Santa Fe Limited 2009 ; Manual A/C Wiring Diagram (2 of 2) for Hyundai Santa Fe Limited 2009. Rear A C Wiring ...

Hyundai Santa Fe (2006-2012) EMP300RDS pinout

https://pinoutguide.com > ... > Hyundai Santa Fe pinouts

Dec 10, 2019 - Hyundai Santa Fe (2006-2012) EMP300RDS pinout ... Audio Head units > Hyundai Santa Fe pinouts · 24 pin Hyundai Head Unit connector layout

2009 Hyundai Santa Fe Radio Wiring Harnesses - Crutchfield

https://www.crutchfield.ca > ISEO-rgbtcspd > ymm > 2...
Need a radio wiring harness for your 2009 Hyundai Santa Fe? Get free shipping and free lifetime tech support with your order.

all the radio wiring harness diagrams are available online by Googling


year make model radio wiring


https://www.google.com/search?q=wiring+diagram+for+Toyota+8600-00977+radio

The radio part number isn't as helpful in solving

..

Pin 1 - Signal (Green/Yellow) Pin 2 - Signal Return (Grey/Red) Pin 3 - Signal (Orange/Red) Pin 4 - +5V Reference (Orange/Yellow) Pin 5 - Ground (Black) Pin 6 - Not Used

No tire pressure needed just ride on rims

There could be no relay in the vehicle because it doesn't need one. CANbus vehicles tend to use a single module to carry out all the vehicle timing requirements - indicators, hazards, wipers, courtesy lights and so forth.
If the flashers don't work it would be better to repair the system than to rewire and use an outdated method, perhaps introducing further fault codes that might affect the operation of other stuff.

A little used hazard switch is a common cause of flasher failure...

If you really must rewire the system, the (ignition) live, as you say, goes to one side of the flasher unit and the other to the centre contact of the indicator switch though you will need a wiring diagram to identify the colour. There is no single universal colour code though if I was looking at an old British car I would expect to see a dark green wire with a thin black trace line.

A wiring diagram will be useful also for identifying the wiring to the lamps and separating the hazard switch wiring from the circuit. If there are two dashboard tell-tale lights the 2-pin relay will be ok but if there is only one you will need a 3 or 4 pin unit depending on whether electronic or electro-mechanical.

normally during manufacturer the wires in one half of the connection line up with the same colour wire in the other half of the connection
makes for easier installation on assembly

this is the wiring color code for the vehicle, so review the colors, and match them to the pin out of the new unit. The list is in th emiddle of the page.

1995 Buick LeSabre Stock Radio Wiring Diagram

Hi Red, Sorry to tell you this pal, but the Toyota's we have worked on do not have a colour coding format for most of the wiring loom. A cable which is loomed from the speed sensor can be one colour going in and another colour coming out because Toyota join cables of any colour, presumably for cost effectiveness. The cable can be identified from the pin number inside the management computer, or by downloading a pin out diagram from <www.allpinouts.com> Regards John.

i have just put one in mine!

the only way you can do it if the plugs are not on, will
be to colour code the wires to pins. if you need the colour to pin codes
let me know.

All the best.